User manual KENWOOD TK-8302

[. . . ] Government law prohbts the operaton of unlcensed transmtters wthn the terrtores under government control. SAFETY: It s mportant that the operator s aware of, and understands, hazards common to the operaton of any transcever. Do not carry spare fuel contaners n the trunk of your vehcle f your transcever s mounted n the trunk area. INJURY FROM RADIO FREQUENCY TRANSMISSIONS Do not operate your transcever when somebody s ether standng near to or touchng the antenna, to avod the possblty of rado frequency burns or related physcal njury. [. . . ] The left and right dots on the display can be programmed to indicate specific modes of operation, as listed below. The , , , , S, A, <B, C>, and keys can be programmed with the functions listed below. Direct Zone Channel can be programmed only on the S, A, <B, C>, and Emergency can be programmed only on the key. If the Transceiver Password function is programmed, "PS" will appear on the display when the power is turned ON. When using a keypad, simply enter the password digits and proceed to step 3. If Squelch Off has been programmed onto a key, you can use that function to listen to background noise while adjusting the volume level. Select the desired zone and channel using the keys programmed as Zone Up/ Zone Down and Channel Up/ Channel Down. While scanning, the transceiver checks for a signal on each channel and only stops if a matching signal is present. The transceiver will remain on the busy channel until the signal is no longer present, at which time Scan resumes. Note: To use Scan, there must be at least 2 channels added to the scanning sequence. If a Priority channel has been programmed, the transceiver will automatically change to the Priority channel when a call is received on that channel, even if call is being received on a normal channel. During scan, you can temporarily remove specific channels from the scanning sequence by pressing the key programmed as Scan Delete/Add while Scan is paused at the undesired channel. However, when scanning is ended and restarted, the Scan settings return to normal. You can add and remove zones and/or channels to and from your scan list. 2 Press the key programmed as Scan Delete/Add to remove a channel or press and hold the key for approximately second to remove a zone. The Scan Revert channel is the channel selected when you press the PTT switch to transmit during scan. Your dealer can program one of the following types of Scan Revert channels: Selected + Talkback: Same as "Selected", plus you can respond to calls on the channel at which scan is paused. Priority + Talkback: Same as "Priority", plus you can respond to calls on the channel at which scan is paused. â· Last Called + Selected: The last channel on which you receive a call or the last channel selected before scan, whichever operation occured latest. Note: To make DTMF calls, you must use an optional microphone with a DTMF keypad. If Keypad Auto-PTT is enabled by your dealer, you do not need to press the PTT switch to transmit; you can make the call simply by pressing the keys. Autodial allows you to quickly call DTMF numbers that have been programmed onto your transceiver. [. . . ] N Lone Worker Mode Lone Worker Mode is a safety feature built into the transceiver. If the transceiver is not operated for a pre-programmed period of time, the transceiver will emit a tone and automatically enter Emergency operation. Press and hold the key programmed as Lone Worker for 2 seconds to toggle the Lone Worker function ON or OFF. During interruptions in service (such as a power failure), you can continue to communicate by using the Talk Around feature. [. . . ]