User manual KRANZLE 1050 TS

[. . . ] Crank handle with fastening screw Explanatory symbols affixed to the high pressure cleaner In case of improper use, the high pressure jet can be very dangerous. Do not direct jet at persons, animals or active electrical equipment or the machine itself. Fastening hook for electric cable with two fastening screws Original-Betriebsanleitung Hochdruckreiniger K 1050 TS T -D- The unit may not be connected directly to the public drinking water supply network. Water connection supply, plug coupling with visible filter 30 31 General rules Safety precautions Range of application Use machine for cleaning tasks with high pressure water jet and detergents or with high pressure water jet without detergents only. [. . . ] When using an extension cable, this must have an earthed lead which is properly connected to the socket. The conductors in the extension cable must have a minimum cross section of 1. Plug connections must be of a spray-proof design, and may not be located on a wet floor. With extension cables of more than 10 m the minimum cross section must be 2. When using a cable drum, always keep the cable wound as far as possible. Water supply Please pay attention to the regulations of your waterworks company!In accordance with DIN EN 61770, the machine may not be directly connected to the public drinking water supply lines. A brief connection however is permissible according to DVGW (German Association for Gas and Water Affairs) if a non-return valve with tube ventilator (Kränzle order no. Once the water has passed through the non-return valve it is no longer considered as drinking water. Also indirect connection to the public drinking water supply lines is permissible by way of free emission in accordance with EN 61 770; e. direct connection to a non-drinking water supply line is permissible. 36 37 Functional details Functional details Water and cleaning / care products system Water can be connected at mains pressure to the high pressure pump. The water is then forced under pressure by the high pressure pump to the lance. The high pressure jet is formed by the nozzle at the end of the lance. environmental , refuse disposal and water protection regulations must be observed!Motor overload protection The motor is protected against overloading by means of an overload protection device included in the motor coil. In the event of overloading or jamming, the excess temperature cut-out serves to switch off the motor. In case of repeated switching GB off the motor by means of the excess temperature cut-out, make sure to eliminate the cause of the failure. Replacements and inspection work should only be performed by qualified persons when the machine is disconnected from the power supply, i. Lance with trigger gun with safety catch The machine can only be operated when the trigger of the trigger gun with safety catch is pulled. The spray pressure increases and quickly reaches the selected operating pressure. When the trigger is released, the trigger gun closes and any further spraying of liquid from the lance is stopped. [. . . ] 01, 2015 Take a wire (paper clip) and clean valves under running water. Josef Kränzle (Managing director) 48 49 Warranty Notes Warranty Our warranty obligation is understood to exclusively cover material and manufacturing defects; wear is not covered by warranty. The machine is to be operated in conformity with this Operating manual. This warranty shall only apply on condition of proper use of original-Kränzle component parts and original-Kränzle replacement parts. [. . . ]