User manual KRESS 1100 BMH MAX

[. . . ] For the attachment of identification markings on the machine, do not drill into the housing. Therefore, always take a secure stance and hold the machine firmly with both hands. Typically the A-weighted noise levels of the machine are: sound pressure level LpA = 89 dB (A); sound power level LwA = 100 dB (A). [. . . ] 9 Rotational direction switch 10 Drilling/Impact drilling selector 11 Holder for depth stop 12 Auxiliary handle 13 Adapter for screwdriver bits/drill chuck Accessories illustrated or described are not always included as standard delivery items. With light pressure on the on/off switch 6, the machine begins to rotate slowly; with increased pressure, the speed increases. rOTATIONAL DIRECTION SWITCHING Operate the rotational direction switch 9 only when the machine is at a standstill!If the rotational direction switch 9 is set between the positions "R" and "L", the machine cannot be switched on. Use only an original Kress mains cable module that is at least of heavy rubber sheathed cable (Code designation H07 RN-F). Check before putting into operation that the mains voltage agrees with the voltage specified on the nameplate of the machine. STOP ROTATION Two settings can be selected with the stop-rotation switch 4. The gear switches to the preselected setting after actuating the on/off switch 6, respectively when the machine starts running. Only after the on/off switch 6 is actuated and the machine starts does the gear box shift to the selected mode. After heavy use over a long period, the machine should be taken to a Kress service location for an inspection and thorough cleaning. Check the area to be worked with a metal detector, for example, before starting. For metal, use only flawless, sharpened drills; for stone and concrete, only masonry drills with hard metal inserts. Always adapt the speed to the material to be worked and the diameter of the drill. For precision working with metal and wood, place the machine in a drill stand (accessory). Do not dispose of electric tools together with household waste material!These instructions are printed on recycled paper manufactured without chlorine. Subject to change without notice CE Declaration of conformity We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: see CE Technical file at: see TF This electro-tool was manufactured with high precision and subjected to rigorous factory quality controls. Therefore, we guarantee the cost-free correction of fabrication or material defects that occur within 24 months of the date of purchase by the end user. [. . . ] Therefore, we guarantee the cost-free correction of fabrication or material defects that occur within 24 months of the date of purchase by the end user. We reserve the right to repair defective parts or replace them with new parts. Improper use or handling as well as opening of the machine by unauthorised repair agencies voids the guarantee. [. . . ]