User manual KRESS 144 AFB 2.6

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Work area safety User action Action for working with the device, start with light pressure and increase the pressure slowly until the desired operation is achieved. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. for a clearer understanding , please consult the enclosed illustrations showing the device. Have these illustrations to hand and open while reading the operating instructions. Device description The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to underestimation of vibration when the tool is used regularly in such a manner. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually when doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and accessories, keep the hands warm, organisation of work patterns. Torque soft joint Noise levels LpA = A-rated sound pressure level = A-rated sound power level LwA K = Measurement uncertainty value The noise level can exceed 85 dB(A) during operation. Triaxial vibration emission level determined in accordance with EN 60745. If the rotational direction switch V is in centre position, the lamp can be used without rotational movement of the driver. Before putting the tool into operation, check that the mains voltage and frequency on the type plate match the details of your mains supply. Mains cable charger Fixed power supply Fixed power supply Damaged mains cables must not be used. Charging the battery Only put original batteries into the battery charger!During the charging process, both the battery and the charger heat up. Red - green flashing light - battery is charged, charger has switched to trickle charge. The charging process begins automatically as soon as the battery reaches a temperature within the permissible range. Removing the battery To remove the battery 5, press the release button(s) VIII and pull the battery out of the power tool. Inserting the battery Use only original KRESS batteries with the voltage given on the type plate of your machine. Set the rotational direction switch V to the middle position to prevent it being switched on accidentally. Insert the charged battery 5 into the handle until you feel it click into place. [. . . ] Remove the battery from the device before undertaking any work on the device. Regularly wipe off the plastic parts which are accessible from the outside using a cloth without cleaning agent. EN Only for EC countries: Defective or dead out battery packs/batteries must be recycled according the guideline 2006/ 66/EC. These batteries contain cadmium, a highly toxic heavy metal Nickel-metallic hydride battery After heavy use over a long period, the machine should be taken to a Kress service location for inspection and thorough cleaning. [. . . ]