User manual KRESS 6066

[. . . ] Saw blades which are not in accordance with the specifications stated in these operating instructions may not be used. Saw blades may not be braked by a sideways applied counter-pressure after the drive has been switched off. Check that all moving parts of the blade guard function without pinching. It should be ensured that all devices, which cover the blade, are functioning properly. [. . . ] Of course the cut depth for rectangular cuts would in this case only be 59. Observe proper usage of the circular saw: Cutting wood and wood-like substances with circular blades only. Before using the machine for the first time Before starting the saw, check that the mains voltage is the same as that on the type plate of the device. Safety switch with lock off safety position Before activating the on/off switch (1) in the hand grip, the switch must be unlocked by pressing the switch release (2). Only then can the machine be switched on by pressing the on/off switch. Fixing the on/off switch for prolonged operation is not possible for safety reasons. When the on/off switch is released the power supply is interrupted and the machine comes to a halt. the switchon block automatically blocks the switch thus preventing unintentional activation of the machine. Cleaning procedure and maintenance Long motor life will be your reward when you make the minor effort of blowing the sawdust out of the ventilation openings in the housing after each job, since optimum ventilation is a critical factor in motor life. From time to time, clean the resin deposits out of the sawdust ejector (please do not use caustic cleaning agents). The saw motor is permanently lubricated and so needs no special maintenance. However, if you use the saw for heavy-duty jobs over a long period of time we recommend that you occasionally send it to our service department for This will save you money for repairs and increase the service life of your tool. Base The base (14) has been set in the factory so that it makes an angle of exactly 90° with the blade in basic position (zero mark on scale). Swing guard The swing guard (11), which covers the blade, moving back automatically when the blade is brought into the work, at the same rate at which the saw is brought in. When you reach the end of the cut, the swing guard moves back by spring action to cover the blade again. The base (14) can be pressed downwards, thus being moved in direction cutting depth "0" when the clamp lever (7) on the casing is released. The cutting depth can be read off from the indicator (24) or reset according to the scale. Sawing to layout lines On the front edge of the circular saw base, there is a marker (indentation) for rectangular cuts (zero setting), which corresponds to the blade width. When following the layout line, make sure that you cut respectively according to the left or right edge of the indentation or marking tongue, depending on whether you are sawing to the left or right of the layout line. Setting the angle of cut The base (14) can be tilted up to 45° for bevel cuts. First loosen the two clamp levers (6) on the angle scales incline the base according to the scale and then retighten the clamp levers. the folded over part on the angle scale points to the 0°-position. [. . . ] Consignes de sécurité et protection contre les accidents Avant de mettre la machine en service, lire entièrement la notice d'utilisation, observer les consignes de sécurité énoncées dans cette notice ainsi que les consignes de sécurité générales s'appliquant aux outils électriques, citées dans la brochure ci-jointe. Ställ in spaltkilen (12) så att avståndet till kuggspetsarna och till sågklingans nedersta punkt max. We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: EN 50144, HD 400, EN 55014-1, EN 55014-2, EN 61000-2-3, EN 61000-3-3 according to the provisions of the regulations 73/23/EEC, 89/336/EEC, 98/37/EC. This electrical tool has been designed with high precision and was approved after undergoing strict quality control checks in the factory. [. . . ]