User manual KRESS SPS 650W

[. . . ] SPS-DE / 0912 Original instructions "Jig saw“ Symbols and abbreviations English 15 Work area Keep work area clean and well lit. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. [. . . ] Use only an original Kress mains cable module and at least a heavy rubber tube cable (H07RNF). Restarting protection The restarting protection feature prevents uncontrolled restarting of the machine after an interruption in the power supply.  To restart the operation, switch the On/Off switch 1 to the Off position and start the machine again. Pendulum stroke setting The change-over from the setting 0-3 is effected by means of the pendulum-stroke adjusting knob 7 (turning knob). 0 for glass, ceramics, soft steel, nonferrous metals, aluminium and pressed materials Pos. 3 for plastics for plywood for hardwood, softtextured wood, chipboard It should be noted that the values given are standard values which may vary according to thickness and hardness of material, grain direction, and also to the condition of the saw blade. The optimal orbital action setting for the respective application can be determined through practical testing. The following recommendations apply:  Select a lower orbital action setting (or switch it off) for a finer and cleaner cutting edge.  For soft materials and when sawing in the diSPS-EN / 0912 Operation The wood fibres are thus pressed against the stress corrosion protection 13 or 15 during sawing, which prevents the edges being torn. Dust suction Insert the suction connection piece 9 into the saw bench 4 from the back. The jigsaw can now be connected to a commercially available vacuum cleaner. To keep the cut free of shavings, insert the flexible suction hose into the opening of the suction connection piece. Digital electronic control The stroke speed can be adjusted stepless from 500 spm to the maximum stroke rate of 3200 spm, and thus adapted to the respective material requirements. When under load, the digital electronic control provides for more power. Regulation is carried out via the speed control dial 2 at the front of the handle. 3200 strokes/min Clamping blades English 21 Wear safety gloves for tool changing. The tool insert can become very hot after working for long periods and/or EN the cutting edges of the tool insert are sharp. And unclamping the saw The advantage of the clamping system is that saw blades can be changed without tools. Turn the tension lever 6 to open the quick-change clamping system so that the saw blade 8 can be inserted. By releasing the tension lever 6 and then push-ing in the direction of the tappet, it is automatically fixed in position, and the tension lever 6 returns to the neutral position. When unclamping the saw blade 8, it is released from the fixed position by turning the tension lever 6. The protection roller, which prevents the saw blade from moving and serves to unburden the mechanical parts (tappet), automatically produces a clamping angle of 90° as a positive stop. [. . . ] In certain countries there are special regulations concerning the warranty terms. Inappropriate use or handling and opening up the device by unauthorised repair centres leads to the warranty becoming void. , damage caused by penetration of water or other fluids, cut and damaged cables, motor damage and mechanical damage caused by inappropriate overloading, wear parts e. Carbon brushes, drill chucks, chuck keys, worn drilling spindles, motors, mains cables, batteries, saw blades, grinding discs, dust bags, accessories in general (drill bits, chisels etc. [. . . ]