User manual LA CROSSE TECHNOLOGY TX21U INSTRUCTION MANUAL

[. . . ] After all information has been displayed for 15 minutes you can place your sensors outdoors and set your time. Important Notes on Set-up and Operation · · · · · The remote temperature/humidity sensor is both the source of power for both outdoor sensors and source of transmission for all remote sensor data. The remote temperature/humidity sensor should be placed in a dry, shaded area. Fog and mist will not harm your remote temperature/humidity sensor but direct rain must be avoided. [. . . ] Place both units in their desired location, and wait approximately 15 minutes before permanently mounting to ensure that there is proper reception. The indoor weather station should display a temperature and humidity in the OUTDOOR LCD and wind speed (can be 0. 0) in the WIND SPEED LCD within 4 minutes of setting up. THE REMOTE TEMPERATURE/HUMIDITY SENSOR The remote temperature/humidity sensor can be mounted in several ways: · With the use of screws · Using adhesive tape · Using nylon straps A. MOUNTING WITH SCREWS 1) Remove the mounting bracket from the remote temperature/humidity sensor. 3) Through the two screw holes of the bracket, mark the mounting surface with a pencil. MOUNTING WITH ADHESIVE TAPE 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. 3) Adhere the tape to the designated area on the back of the mounting bracket. 5) Position the remote temperature/humidity sensor in the desired location, ensuring that the indoor weather station can receive the signal. MOUNTING WITH NYLON STRAPS 1) Remove the mounting bracket from the remote temperature/humidity sensor. 3) Place the remote temperature/humidity sensor in your desired mounting location. 4) Fasten the two nylon straps securely around the mounting location. II. · · THE REMOTE WIND SPEED SENSOR The remote wind speed sensor can be mounted two ways: With the use of screws Using nylon straps A. MOUNTING WITH SCREWS 1) Unlock the mounting bracket from the remote wind speed sensor leaving the wire going through the bracket. 3) Through the two screw holes of the bracket, mark the mounting surface with a pencil. 5) Slide the remote wind speed sensor onto the bracket making sure to lock it in place. MOUNTING WITH NYLON STRAPS 1) Unlock the mounting bracket from the remote wind speed sensor leaving the wire going through the bracket. 5) Slide the remote wind speed sensor onto the bracket making sure to lock it in place. III. THE INDOOR WEATHER STATION 1) Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall. 2) Place the indoor weather station onto the screw using the hanging hole on the backside. 3) Gently pull the indoor weather station down to lock the screw into place. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology. 2) Be sure indoor weather station is at least 6 feet from any electrical devices, such as televisions, computers, or other radiocontrolled clocks. 3) Remove batteries for five minutes, reinsert and leave the unit alone overnight without pressing buttons. Solution: Be sure correct time zone and daylight saving time settings are selected. [. . . ] THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: La Crosse Technology, Ltd 190 Main Street La Crescent, MN 55947 Phone: 507. 895. 7095 Fax: 507. 895. 2820 e-mail: support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) web: www. lacrossetechnology. com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. [. . . ]