User manual LAGRANGE 339903

[. . . ] Never immerse the appliance in water or any other liquid for any reason whatsoever. Should the cord be damaged, it must be replaced by a competent qualified electrician*. Never use the appliance outside and always place it in a dry environment. [. . . ] Never use the appliance outside and always place it in a dry environment. They could constitute a danger to the user and risk to damage the appliance. Make sure the appliance has cooled down before cleaning and storing it. Make sure the cord never comes into contact with the hot parts of the appliance. Make sure the appliance never comes into contact with inflammable materials, such as curtains, cloth, etc. Be careful not to scratch the special coating of the cooking plate, as you might get little pieces of this coating into the food. Always unplug the appliance when it is not in use, especially since it is not equipped with an on/off switch. People (including children) who are unfit to use the appliance under conditions of complete safety either due to their physical, sensorial or mental capacities, or due to their lack of experience or knowledge, may not use this appliance under any circumstances unless they are watched by, or receive instructions from, a responsible person. open the toaster and remove sandwich using a plastic or wooden spatula. Close the lid to preserve the heat until you are ready to toast the next sandwiches. Prepare additional sandwiches if desired while the others are cooking. If a BS1363 approved 13 amp plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour coded: blue = neutral, brown = live, green or green & yellow = earth. The blue wire must be connected to the terminal marked N or coloured in black. The brown wire must be connected to the terminal marked L or coloured in red. The green (& yellow) wire must be connected to the terminal marked E or coloured in green (& yellow). [. . . ] The blue wire must be connected to the terminal marked N or coloured in black. The brown wire must be connected to the terminal marked L or coloured in red. The green (& yellow) wire must be connected to the terminal marked E or coloured in green (& yellow). [. . . ]