User manual LG LH-C6230

[. . . ] Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. Should this happen, unplug or main switch off the unit and contact an authorized service center. Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. Should this happen, switch off the breaker used for your air conditioner and contact your installation specialist. [. . . ] Example: E-6 Inserting the Remote Control Batteries You must insert or replace the remote control batteries when: x You purchase the air conditioner x The remote control does not work correctly Use two AAA, LR03 1. 5 V batteries. Batteries may be completely discharged after 12 months, even if they have not actually been used. 1 2 Push the battery cover on the rear of the remote control with your thumb in the direction of the arrow and remove it. Insert the two batteries, taking care to respect the polarities: x + on the battery with + on the remote control x ­ on the battery with ­ on the remote control Close the cover by sliding it back until it clicks into place. Result: You can control all the functions on your air conditioning unit directly from your seat, using the remote control. 3 E-7 Cooling Your Room Remote Control Control Panel You must select the Cool mode if you wish to lower the temperature in your room. You can also set the fan speed. 1 If necessary, press the (On/Off) button. x The operating mode indicator (COOL, FAN or HEAT) on Result: the unit comes on. x The air conditioner starts up in the mode selected when the unit was last used. air Theunit conditioner is fitted with a protection mechanism to prevent the from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up automatically after about three minutes. 2 If the COOL indicator is not lit up on the unit: x Press the button on the remote control or x Press the MODE button on the unit one or more times until the COOL indicator lights up x The unit beeps each time you press MODE. Result: x The air conditioner starts up in Cool mode. 3 You can change modes at any time. To adjust the temperature, press the or button on the remote control one or more times until the required temperature is displayed. To adjust the temperature, press the or button on the unit one or more times until the required temperature is displayed. x Each time you press the temperature buttons: Result: ­ The temperature is adjusted by 1°C and displayed on the control panel ­ The unit beeps x The air conditioner starts cooling if the room temperature is higher than the selected temperature. 4 To set the fan speed to. . . or x on the remote control or unit (The air conditioner operates in the mode selected when the unit was last used. ) E-12 Setting the Off Timer The Off Timer enables you to switch off the air conditioner automatically after a given period of time. You can select the Off timer only when the air conditioner is on. Remote Control Control Panel 1 Check that the air conditioner has been switched on; if necessary, press the (On/Off) button. 2 Set the operating time by pressing: x Timer on the remote control or x Timer on the unit one or more times. Result: x The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. x The air conditioner switches off automatically when the operating time reaches zero. You can change the setting mode, fan speed, and air flow direction after setting the Off timer. To Cancel the Off Timer To cancel the Off timer, press: x Timer on the remote control or unit one or more times until " " is displayed. or x on the remote control or unit (The air conditioner operates in the mode selected when the unit was last used. ) E-13 Setting the Sleep timer The Sleep Timer can be used when you are cooling or heating your room to switch the air conditioner off automatically after a period of 8 hours. Remote Control Control Panel 1 2 If you wish to switch the unit off at a specific time, refer to page 13. Press the or Press the Result: button on the remote control button on the unit until the SLEEP indicator lights up. x The "SLEEP" passes through the control panel for about 15 seconds and the " " will be displayed. x The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. x The air conditioner will be controlled as illustrations below. Cooling When the temperature has been increased by 1°C (after 1 hour), it is maintained for 7 hours. Set TEMP. Start time 1hr 8hr Stop time Heating The temperature is decreased by 1°C after 1 hour. When it has been decreased by 2°C (after 2 hour), the temperature is maintained for 6 hours. To Cancel the Sleep Timer To cancel the timer, press: x on the remote control. [. . . ] (Be sure not to use benzene, solvent or other chemical products. ) If you. . . Will not be using the air conditioner for a long period of time Then. . . x Set the fan going for a few hours to dry the inside of the air conditioner thoroughly. Set the fan going for a few hours to dry the inside of the air conditioner thoroughly. The air conditioner has two or three grille grooves depending on the model. Have not used the air conditioner for a long period of time E-17 Cleaning Your Air Conditioner (AA models) Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. 1 When cleaning the air conditioner, turn it off and pull out the power plug. Open the front grille by pulling on the tabs of the unit. The removal of the front grille makes it easier to clean the air conditioner. After opening the front grille, lift it up as much as possible, then pull down to release it. 2 Front grille 3 Grasp the handle on the air filter and lift it slightly and then out to the front. Remove all dust on the air filter with a vacuum cleaner or brush. 4 When you have finished, insert the air filter back into its original position. 5 Wipe the surface of the unit with a neutral detergent and then wipe it again with dry cloth. (Be sure not to use benzene, solvent or other chemical products. ) Front grille Grille groove Body guide If you. . . Will not be using the air conditioner for a long period of time Then. . . x Set the fan to "FAN" and let it for a few hours to dry the inside of the air conditioner thoroughly. [. . . ]