User manual LIEBHERR CBPESF 4013 COMFORT BIOFRESH

[. . . ] In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated. · Do not stand on the plinth, drawers or doors or use them to support anything else. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Accumulated dust increases the energy consumption: - Once a year, dust the refrigerating unit together with the metal grille of the heat exchanger at the back of the appliance. Saving energy 11 Setting the temperature The temperature of the refrigerator and freezer compartment can be set separately. Setting the refrigerator temperature: Press the Up/Down button 3, the LED in the temperature display 4 for the next lower temperature value will light up. Keep pressing the Up/Down button 3 until the desired value is displayed. Setting the freezer temperature: Equipment You can re-arrange the storage shelves as required. Lift the glass shelf, align the recess over the support and replace the shelf in a higher or lower position. Repositioning the door racks - Lift door rack vertically (1), lift out to the front and re-insert at a different height, following these steps in the reverse order (2). - By shifting the bottle holder F you can protect the bottles from falling over when opening or closing the door. Press the Up/Down button 6 until the desired value is displayed in the temperature display 5. Note After a certain period of operation, the interior temperature will adjust to the value which has been set. Audible warning on/off button Audible door alarm If an appliance door is left open for more than 60 seconds, the audible warning signal will sound. The alarm switches back to standby when the door is shut. The appliance is equipped with an alarm function. Insert the glass shelves 1 and 2 as shown in fig. If you need to make space for tall containers, simply slide the front half of the sectioned glass shelf carefully underneath the back half, fig. 1, on the supports on the left and right at the desired height. This can be caused by: · the freezer door being left open for a long time, allowing warm ambient air to enter; · a long power failure; · a fault in the appliance. If the visual warning LED does not go out, contact the customer service department (see section on Malfunctions). Press the audible warning on/off button 8 to cancel the alarm. The lower the temperature, the more ice can be produced over a period of time. The ice cubes fall out of the ice maker into the drawer. When the ice reaches a certain level in the drawer, the appliance stops producing ice automatically. If you require a large quantity of ice you can swap the drawer to the right with the full "IceMaker" drawer. When you close the drawer the ice maker will immediately start production. Freezer compartment The refrigerator compartment defrosts automatically. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Ensure that the water can flow without hindrance through the hole above the vegetable bins. Any moisture arising collects on the evaporator and freezes, and is periodically defrosted and evaporated. Cleaning the ice-cube tray Cleaning · The ice maker must be switched on. · Hold the ON/OFF button for 10 seconds (after 1 second the ice maker will switch off - the LED will go out). · After you have held the ON/OFF button for 10 seconds the LED will start to flash for 60 seconds. The best way of doing this is with warm water and a little washing-up liquid. The ice maker will then immediately restart with its production of ice cubes. [. . . ] ­ Does the appliance cause nearby items of furniture or objects to vibrate?Please note that noises caused by the refrigerant circuit cannot be avoided. · The temperature is not low enough: ­ Is the temperature setting correct (see "Setting the temperature")?­ Have excessive amounts of fresh food been placed in the appliance? [. . . ]