User manual LIEBHERR CBPESF 4043 COMFORT BIOFRESH

[. . . ] W Remove the plastic cover bl from the door mounting and insert on the other side making sure it fits precisely. W Replace the door on the hinge pin 9 at the bottom, guide it across the hinge 7 at the top and insert hinge pin 6. W Rotate cover parts through 180° and re-attach them to the other side, 1, 2 and 3. 2 Torx R 15 1 3 Changing the compartment door* W Fig. [. . . ] W Rotate the door and closure by 180° and replace on the other side: Insert the compartment door at the top, put the hinge 1 in place at the bottom, screw down again and close the cover. 3 A2 Torx R 15 6 * Depending on model and options EK/EKB/EG Installation instructions For appliances with decor frames, fig. B: The front of your appliance can be colour-matched or contrasted with other components of a fitted kitchen through the attachment of a decor panel and frame. The following table shows the panel dimensions for your appliance: Appliance for Decor panel dimensions (mm) recess height height width max. thickness _______________________________________________ 874 - 880 860 585 4 1220 - 1226 1206 585 4 W Graduate thicker decor panels according to fig. Attach handle bq at required height (top or bottom - remove centre screw if at top). W Cover screw heads with cover caps cl Decor panel assembly GB For appliances with decor frames, fig. If the existing decor panel on the replacement appliance is too short, you can adjust the height with equaliser trims available in different heights. Depending on the additional height required, or for visual reasons, you can use either one or two equaliser trims (top and/or bottom). The equaliser trims are available in three different heights and colours (see table below) from your customer service point. E1/2: All installation components are supplied. GB 3 2x 33 1x 36 1x 37 34 30 1x 32 2 x 35 R 2x R o 4 x 19 Torx 15 o 4 x 29 Torx 15 38 2x 39 1x 1x M 5 x 15 Torx R 25 1x 19 mm 5 mm W Slide appliance 3/4 of the way into the kitchen unit. F: slide equaliser trim dl into the channel and engage it in the key holes. W Stick sealing strip dn onto the side of the appliance on the handle side flush with the front: remove the protective film and stick on; shorten to recess height if necessary. W For 16 mm unit wall (568 mm recess): clip spacer do onto the hinge in the slot. W Slide appliance into the recess until the lower hinge 8 abuts the end face of the unit wall, fig. F: - Using a spanner*, vertically align the appliance on the handle side by way of the adjustable foot* du. Pay attention to the following: - The appliance has to be tight-fitting against the side wall at the top on the hinge side!- Align appliance on the hinge-side by way of the adjustable foot in the bearing block 8 using a Torx®30 screwdriver, Fig. - Align the door so that it is in alignment with the surrounding unit doors by means of the elongated slots in the lower hinge 8. [. . . ] - Align the door so that it is in alignment with the surrounding unit doors by means of the elongated slots in the lower hinge 8. W Screw plastic bracket ds with M5 screws dt onto the appliance at the handle side, fig. F, and align so it is flush with the front edge of the unit floor, fig. [. . . ]