User manual LIEBHERR CCE 2318

[. . . ] The same applies to changing the mains power cable. · Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated. [. . . ] The correct climate rating for your appliance is indicated on the type plate. Ambient temperatures +10° to +32°C +16° to +32°C +16° to +38°C +16° to +43°C Dimensions (mm) GT 1456 GT 2156 GT 2656 GT 3056 GT 3756 GT 4756 Model 910 919 919 919 919 919 A 569 754 873 999 1373 1648 B GTP 2356 GTP 2756 919 919 1132 1288 760 760 760 760 760 760 809 809 C 9 Operating and control elements Audible warning signal - It sounds when the lid has been left open for longer than about 60 seconds; (except model GT 1456) - It sounds when it is not cold enough in the freezer compartment. The temperature display will also flash. Temperature setting buttons On/Off button Audible warning on/off button Child lock LED SuperFrost LED SuperFrost button Temperature display The audible warning device is switched off by pressing the ALARM button. The audible warning device helps to protect the frozen food and to save energy. Switching the appliance on and off - The two illuminated dashes of the digital temperature display will light up until a temperature of 0°C is reached. - If the temperature is below 0°C, the digital temperature display will show the temperature inside the appliance. To switch the appliance on: Press the ON/OFF button until the temperature display lights up. You are recommended to clean the appliance before switching it on for the first time (see Cleaning). If you press the ALARM button whilst the display is reading nA, the highest temperature registered during the power failure will be displayed. Check the quality of the food and its suitability for consumption in case it has become too warm or even defrosted. The display can be switched off by pressing the ALARM button. If nA appears in the display, this means that the freezer temperature has risen too high during the last few hours or days due to a power failure. Power failure display Additional functions Keypad lock The keypad lock ensures that no unintentional changes are made to the electronic control system. To switch the appliance off: Press the ON / OFF button for approx. 3 seconds so that the temperature display goes out. Setting the temperature Activating the keypad lock Press for 5 seconds. Display = Display = Display = Display = Display = · To reduce the temperature: Press the bottom button Down. · To increase the temperature: Press the top button Up. - While you are entering the temperature, the set temperature will flash on the display. - You can change the settings in increments of 1°C briefly pressing the button again. If the buttons are held down the temperature setting will change faster. - The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature in the freezer will be displayed. It will be kept at the right temperature by means of a safety circuit. Consult your nearest customer service point. 10 Freezing Deactivating the keypad lock Press for 5 seconds. Display = Display = Display = Display = Display = GB Fresh food should be frozen to the core as rapidly as possible. The maximum amount of food in kg which can be frozen in 24 hours is shown on the type plate (Freezing capacity). NB: The upper stacking limit is the top level of the basket! SuperFrost Adjusting the display brightness Press for 5 seconds. Display = Display = Display = Use buttons and to select the desired setting. · Press the SuperFrost button. Depending on the quantity of food placed in the freezer, this will normally be between 48 and max. [. . . ] The type plate is located on the top of the right-hand side wall of the freezer. This will stop cold from escaping and the temperature from rising. Shutting your appliance down Cleaning If your appliance is to be shut down for any length of time, switch it off and disconnect the plug or switch off or unscrew the fuse. Clean the appliance and leave the lid open in order to prevent unpleasant smells. [. . . ]