User manual LIEBHERR CN 5113

[. . . ] · When disconnecting the appliance, pull on the plug, not on the cable. · Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. · Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. [. . . ] The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. Connect the appliance with a properly earthed fused plug and socket only. Setting the freezer temperature: Press the Up/Down button 6 until the desired value is displayed in the temperature display 5. Note After a certain period of operation, the interior temperature will adjust to the value which has been set. - Always ensure good ventilation. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - If there is a thick layer of frost in the appliance: defrost the appliance. - Empty and switch off refrigerating unit for longer vacation periods. Accumulated dust increases the energy consumption: - Once a year, dust the refrigerating unit together with the metal grille of the heat exchanger at the back of the appliance. Saving energy Audible warning on/off button Audible door alarm If an appliance door is left open for more than 60 seconds, the audible warning signal will sound. Press the audible warning on/off button to cancel the alarm. The alarm switches back to standby when the door is shut. The appliance is equipped with an alarm function. Audible/visual temperature alarm If the temperature in the freezer compartment rises too high, the audible warning signal will sound and the LED in the audible warning on/off button will flash. The LED will go out as soon as the temperature in the freezer compartment is low enough. This can be caused by: · the freezer door being left open for a long time, allowing warm ambient air to enter; · a long power failure; · a fault in the appliance. If the visual warning LED does not go out, contact the customer service department (see section on "Malfunctions"). 9 Equipment You can re-arrange the storage shelves as required. Cooling Storage example Lift the glass shelf, align the recess over the support and replace the shelf in a higher or lower position. Repositioning the door racks - Lift door rack vertically (1), lift out to the front and re-insert at a different height, following these steps in the reverse order (2). butter, cheese eggs, cans, tubes bottles frozen food, ice cubes meat, sausage products, dairy products baked goods, pre-cooked meals, drinks fruit, vegetables, salad - By shifting the bottle holder F you can protect the bottles from falling over when opening or closing the door. Insert the glass shelves 1 and 2 as shown in fig. If you need to make space for tall containers, simply slide the front half of the sectioned glass shelf carefully underneath the back half, fig. 1, on the supports on the left and right at the desired height. Note · Food which gives off or absorbs odours and flavours as well as liquids should always be stored covered or in closed containers. High- percentage alcohols should be tightly sealed and stored upright. · Fruit, vegetables and salad can be stored unpacked in the bins. · Reuseable plastic, metal, aluminium and glass containers can be used for packaging. · Allow hot food to cool to room temperature before storing it in the appliance. Cooling with fan This is recommended: - in high room temperatures (approx. during the summer). With the fan function switched on, a uniform temperature distribution will be attained in the refrigerator compartment. To switch on Press the fan button 2 - the LED in the button will come on. 2 Interior light Bulb data: 25 W (never use a bulb rated at more than 25 W). [. . . ] The area of ventilation underneath the ceiling should be at least 300 cm2. 50 mm must be provided on the hinge side between the appliance and the wall (for the handle when the door is open). To adapt the height of the appliance to the surrounding furniture a top unit 1 can be added. 5. Remove bottom door. 1 top unit 2 refrigerator-freezer 3 kitchen unit side panel 4 wall 7. Transfer plug. Shutting your appliance down If your appliance is to be shut down for any length of time, switch it off and disconnect the plug or switch off or unscrew the fuse. [. . . ]