User manual LIEBHERR CNESF 5123 COMFORT NOFROST

[. . . ] The same applies to changing the mains power cable. • This appliance can be used by children of 8 years old and over, and also by persons with restricted physical, sensory or mental capacity or lack of experience and knowledge, if they are supervised or have been instructed on safe use of the appliance and understand the resulting risks. Cleaning and user maintenance must not be carried out by children without supervision. • Avoid prolonged skin contact with cold surfaces or chilled/frozen food. In the case of prolonged skin contact, protective measures should be taken, e. g. [. . . ] Do not use stand-alone inverters (conversion of direct current to alternating current/threephase current) or energy-saving plugs. Risk of damage to the electronic control system! 14 Audible warning on/off button The appliance is equipped with an alarm function. Audible door alarm If an appliance door is left open for more than 60 seconds, the audible warning signal will sound. Audible/visual temperature alarm If the temperature in the freezer compartment rises too high, the audible warning signal will sound and the LED in the audible warning on/off button will flash. The LED will go out as soon as the temperature in the freezer compartment is low enough. You can re-arrange the storage shelves as required. Equipment GB Lift the glass shelf, align the recess over the support and replace the shelf in a higher or lower position. This can be caused by: • the freezer door being left open for a long time, allowing warm ambient air to enter; • a long power failure; • a fault in the appliance. If the visual warning LED does not go out, contact the customer service department (see section on "Malfunctions"). - By shifting the bottle holder F you can protect the bottles from falling over when opening or closing the door. Repositioning the door racks - Lift door rack vertically (1), lift out to the front and re-insert at a different height, following these steps in the reverse order (2). Using the sectioned shelf Place the shelf rails provided, fig. 1, on the supports on the left and right at the desired height. - Always ensure good ventilation. - Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat. - The energy consumption depends on the installation conditions, e. g. - Keep all food properly packed and covered so as to avoid its frosting up on the outside. - Always allow hot food to cool to room temperature before placing in the appliance. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Ensure that the water can flow without hindrance through the hole above the vegetable bins. Any moisture arising collects on the evaporator and freezes, and is periodically defrosted and evaporated. • The ice maker must be switched on. The ice-cube tray can be cleaned. Use the following method. • Remove any ice cubes from the drawer. • Hold the ON/OFF button for 10 seconds (after 1 second the ice maker will switch off - the LED will go out). • After you have held the ON/OFF button for 10 seconds the LED will start to flash for 60 seconds. The best way of doing this is with warm water and a little washing-up liquid. • Clean the side panels and door surfaces with a clean and soft cloth. - Do not use abrasive sponges or scourers, do not use concentrated cleaning agents and never use cleaning agents containing sand, chloride or acid or chemical solvents, as these would damage the surfaces and could cause corrosion. Before cleaning always switch off the appliance. Pull out the mains plug or remove/unscrew the fuse. Cleaning • Clean the inside and equipment parts with lukewarm water and a little detergent. • Press the ON/OFF button and close the drawer. The ice maker will then immediately restart with its production of ice cubes. • Do not damage or remove the type plate on the inside of the appliance. It is very important for servicing purposes. • Clean the drain hole in the refrigerator compartment with a thin object, e. g. cotton swab or the like. • Dry all parts well with a cloth. • Ensure that no cleaning water penetrates into the electrical components or ventilation grille. • The water tank and the cover can be washed in a dishwasher (max. [. . . ] Clean the appliance and leave the door open in order to prevent unpleasant smells. The appliance complies with the relevant safety regulations and EC Directives 2004/108/EC and 2006/95/EC. • The ice maker cannot be switched on: - Is the combined refrigerator-freezer connected to the mains electricity supply? Ice maker malfunctions • The control lamp above the ON/OFF button is flashing: – Is there enough water in the water tank?– Has the water tank been inserted in the mounting and clicked into place correctly?If the control lamp is flashing, even after having checked the abovementioned points, there is a malfunction in the ice maker. [. . . ]