User manual LIEBHERR CNPESF 4613 COMFORT NOFROST

[. . . ] When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated. · Do not stand on the plinth, drawers or doors or use them to support anything else. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] The correct climate rating for your appliance is indicated on the type plate. Ambient temperatures +10°C to +32°C +16°C to +32°C +16°C to +38°C +16°C to +43°C 8 · Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat. · The floor on which the appliance stands should be horizontal and level. To compensate for any unevenness, adjust the height of the feet with the open-ended spanner supplied. Always ensure that there is good ventilation and that the outward flowing air is able to escape. · Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. · Do not connect the appliance to the supply with other equipment using an extension cable - risk of overheating. Setting up Switching the appliance on and off GB You are recommended to clean the appliance before switching it on for the first time (see "Cleaning"). · The temperature display D shows the set interior temperature (on left for refrigerator, on right for freezeer). The visual warning light goes out as soon as the freezer compartment is cold enough. To switch the appliance off: Disconnect the appliance from the mains or set the freezer temperature control to "0". The LED's in the display will go out - the entire appliance will be switched off. To switch the appliance on: Connect the appliance to the mains - the appliance is switched on. To switch the refrigerator compartment off: Set the refrigerator temperature control to "0". 1 kg fresh food daily. 10 Notes on freezing and storage · Pack food which you are freezing yourself in quantities appropriate to your household. To ensure that the food freezes right through, the following quantities should not be exeeded per package: fruit, vegetables: up to 1 kg, meat: up to 2, 5 kg. · Pack frozen food in standard freezer bags or reuseable plastic, metal or aluminium containers. · Do not allow fresh food which is to be frozen to come into contact with food already frozen. · Always write the date and contents on the pack and do not exeed the stated storage time for the food. · Do not freeze bottles and cans which contain carbonated drinks as they might burst. · Only take out as much food as is immediately required for thawing. Use food which has been thawed in prepared meals as quickly as possible. Frozen food can be thawed in the following ways: ­ in a fan oven ­ in a microwave oven ­ at room temperature ­ in the refrigerator: the cold given off by the frozen food is used for cooling. Defrosting GB Refrigerator compartment The refrigerator compartment defrosts automatically. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Ensure that the water can flow without hindrance through the hole above the vegetable bins. Freezer compartment Making ice cubes · Fill the ice-cube tray with water. [. . . ] ­ Does the separately installed thermometer show the correct reading?If none of the above causes apply and you cannot rectify the fault yourself, contact the nearest customer service department stating the type designation 1, service number 2 and appliance number 3 as indicated on the type plate. The type plate is located inside the appliance on the left-hand side. You may be able to rectify the following faults by checking the possible causes yourself: Changing over door hinges 1. Transfer cover plate to the opposite side. Installing appliance in a row of kitchen units A gap of at least 50 mm depth must be provided behind and along the entire width of this unit so as to ensure sufficient ventilation. [. . . ]