User manual LIEBHERR CUP 2901

[. . . ] Gebrauchsanweisung für Doppeltür-Kühl-Gefrier-Automaten Operating instructions for double-door automatic refrigerator-freezers Consignes d'utilisation pour réfrigérateurs double-porte Gebruiksaanwijzing voor dubbeldeurs koelkasten Istruzione d'uso per apparecchi frigo-congelatore a due sportelli Instrucciones de manejo Frigoríficos de doble puerta con congelador Kullama Kýlavuzu Masaüstü Buzdolaplarý 7081 878-00 7081 968-01 CUP 22. . /27. . /30. . . . CUP(esf) 2901 4610 0507 The appliance at a glance Controls, fig. A1: 1On/off and temperature control "7" = cold "1" = warm We recommend a medium setting. Switch on at low room temperatures of 18°C or below. Interior light Bulb data: max. 15 W, voltage and current should agree with the details on the type plate, bulb fitting: E 14. [. . . ] If live parts or the mains lead become damp this may cause short circuits. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions. Risk of injury and danger of damage as a result of incorrect transport!NB: The air temperature in the compartment, measured with a thermometer or other measuring equipment, may fluctuate. However this will have little effect on the frozen food when the compartment is full. The core temperature of the frozen food will be the average of these values. The ice-cubes can be removed from the tray by twisting or by holding upside down for a short time under running water. W On: Turn the temperature control 1, fig. W The positions of the temperature control indicate the following: "1" = warm, lowest cooling setting "7" = cold, highest cooling setting W We recommend a medium setting. W At setting "7" it is possible to reach temperatures below "0" in the coldest zone of the fridge section. Switching the appliance on and off, setting the temperature Making ice-cubes Fresh food should be frozen to the core as rapidly as possible. This ensures that the nutritional value, vitamins, appearW If you are storing frozen food and wish to ensure that the low ance and flavour of the food remain intact. Larger quantities freezing temperature is maintained, we recommend setting of fresh food should be frozen as follows: the temperature control to between "4" and "7". 24 hours before placing the food in the freezer, turn the temperature control to a medium to cold setting (approx. Frozen food already stored will W At low room temperatures of 18°C or receive an additional boost. The maximum amount of food which A1, on the temperature control housing. can be frozen in 24 hours is shown on the type plate This will ensure that the freezer compartment ("Freezing capacity . . . Spread out the fresh food on the bottom of the freezer WAs soon as the Cool Plus switch has been turned on, the apcompartment as much as possible and do not allow it to pliance's interior lighting comes on at a low setting, even with come into contact with frozen food already stored. W The freshly frozen food will be thoroughly frozen after 24 W At normal room temperatures of above 18°C, it is not hours. necessary to switch on the Cool-Plus switch; it should stay - Set the temperature control back to its previous setting. The freezing procedure is NB: Please note that the temperature inside the appliance complete and the appliance will return to its normal coolis affected by the room temperature, the place where the ing function. Freezing fresh food appliance is installed, the frequency with which the door is opened and how full the appliance is. Notes on freezing and storage W As a result of the circulation of the air, the temperature in the refrigerator compartment is not uniform. - Just above the vegetable bins and at the back of the refrigerator, the air is colder, ideal for raw meat or cold meats. - At the top front of the compartment and in the door, the air is warmer, making it ideal for cheese and for spreadable butter. W Store food so that the air can circulate freely; do not place items too close together, and keep at least 2 cm away from the interior light. [. . . ] 2 (11) in the lower door, on the new hinge side, through the middle turn hinge Fig. Fitting the upper door - Place the upper door on the middle bearing pin Fig. - Screw the upper turn hinge firmly into place (with 4 Nm) (2x Torx® 25) Fig. Possibly make preliminary holes with a bradawl or use a cordless screwdriver. [. . . ]