User manual LIEBHERR CUPSL 2901 COMFORT

[. . . ] W Removing drawers: Pull forward until the drawer stops and lift out, fig. A5: If you need space for large bottles and containers, then simply push the front half of glass shelf 1 back. For cleaning, the holder 2 can be used to remove the half glass shelves. A6 1Appliance designation 2 Service number 3 Appliance number 4Freezing capacity . . . [. . . ] W Do not consume food which has been stored for too long, as it could cause food poisoning. WSpecial-purpose lamps (incandescent lamps, LEDs, fluorescent tubes) in the appliance serve to illuminate the appliance interior and are not suited for room illumination. 12 W When setting up/fitting ensure that the refrigerant circuit pipes are not damaged. W Once in position, use a 10 spanner to adjust the feet so that the appliance is level and does not wobble. WStandard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. W Condensation may form on the outside of the refrigerator/freezer during periods of high humidity. W In order to avoid the risk of fire, do not place any burning candles, lamps or other objects with open flames on the refrigerator/freezer. If live parts or the mains lead become damp this may cause short circuits. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions. Risk of injury and danger of damage as a result of incorrect transport!Socket: E 14 - The freezing temperature decreases, the appliance works The current and voltage types should agree with the with the greatest possible freezing capacity. information on the type plate W With a smaller amount of food to be frozen, wait/preW Switch off the appliance. Remove the mains plug, or trigger freeze for approx 6 hours - normally sufficient, with the or remove the fuse. maximum quantity, see freezing capacity on rating plate, W Hold the lamp cover at the front according to the illustration, approx. - The SuperFrost function can be quit manually by briefly WRe-install the cover. pressing button 5, if not: - SuperFrost switches off automatically after approximately 65 hours. - the SuperFrost button is dark - the temperature range set for normal mode lights up in the temperature display. W In order to reach the maximum freezer performance, warm food must be placed directly on the shelves, not in the drawers, or stored in direct contact to the inner side walls. Freezing with SuperFrost Fig. A1/5 Changingtheinteriorlighting 14 * depending on model and options 5 Freezer compartment W As a guideline for the storage time, the following applies to various foodstuffs in the freezer compartment: Ice cream Sausage, ham Game, pork Fish, oily Cheese Fish, lean Poultry, beef 2 to 6 months 2 to 6 months 2 to 6 months 2 to 6 months 2 to 6 months 6 to 10 months 6 to 12 months 6 to 12 months 6 to 12 months Notes on freezing and storage Bread, cakes and pastries W For defrosting, always only remove as much as will be needed immediately. You can defrost frozen food: - in the oven/fan-assisted oven - in the microwave - at room temperature - Defrosted flat meat and fish portions can be heated up. - Vegetables can be prepared in a frozen state (at half cooking time as fresh vegetables). Vegetables, fruit W Suitable packing materials are conventional freezer bags, reusable plastic, metal and aluminium containers. [. . . ] A soft clicking sound, this always occurs when the refrigeration unit (the motor) switches on or off automatically. Motor noise; this will be slightly louder for a brief period when the refrigeration unit switches on. When SuperFrost is switched on, fresh food is inserted, or when the door is open for a long time, the refrigerating capacity increases automatically. The compressor will continue to run for a while - On energy saving models, this is caused by the functions and is perfectly normal. [. . . ]