User manual LIEBHERR EK 1610 COMFORT

[. . . ] 2 2 2 3 3 3 4 4 4 Putting into operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installing the appliance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Water connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] u Plug in the power plug. 5. 2 Child proofing The child-proofing function enables you to make sure that the appliance is not inadvertently switched off by playing children. 5. 2. 1 Setting the child lock u To activate the setting mode: press SuperFrost button Fig. u To switch off: Using the Up setting button, freezer compartment Fig. u To deactivate the set-up mode: press On/Off button, freezer compartment Fig. w The temperature is indicated again in the temperature display. 4. 8 Switching on the appliance Note u To switch on the entire appliance it is necessary only to switch on the freezer compartment. Put the appliance into operation about 2 hours before first loading food to be frozen. Do not load food to be frozen before the temperature display reads -18 °C. 4. 8. 1 Switching on the freezer compartment u Press On/Off button, freezer compartment Fig. w The refrigerator compartment temperature display shows the set temperature. w The temperature display of the freezer compartment flashes until the temperature is sufficiently low. If it is below, the set temperature flashes. 10 Control 5. 3 Door alarm For refrigerator/BioFresh compartment and freezer compartment* If the door is open longer then 60 s, the audible alarm sounds. u To use the bottle shelf: store the glass shelf compactly under the bottle shelf. u Place the bottles with the base pointing backwards facing the rear wall. However do not leave cooled products there otherwise they may be pushed back or tipped over when the door is closed. u Do not store food too close together to enable good air circulation. At the base of the refrigerator compartment, the integrated bottle shelf or alternatively the glass shelf can be used: 5. 5. 4 Relocating the shelves The shelves have stops preventing them from being unintentionally pulled out. 11 Control 5. 6. 2 DrySafe The DrySafe is suitable for storing dry or wrapped food (e. g. A relatively dry storage climate is established here. 5. 6. 3 Storing food u Insert shelf with the raised edge pointing upwards at the back. Note u Vegetables sensitive to cold, such as cucumbers, aubergines, semi-ripe tomatoes, zucchinis and all tropical fruits sensitive to cold, do not belong in the BioFresh compartment. u To prevent food spoilage due to transfer of germs: Store unwrapped animal and vegetable products separate from one another in the drawers. If food has to be stored together due to lack of space: u wrap the food. 5. 5. 5 Using the sectioned shelf 5. 6. 4 Storage times Fig. 27 u Attach the support rails, paying attention to the right (R) and left (L) part!u The glass shelf with stop face (2) has to be at the back. Standard values for storage time at low humidity Butter Hard cheese Milk Sausage, cold meat Poultry Pork Beef Game Always remove the butter and cheese compartment together with the lid. u To remove lid: Press one side part of the butter and cheese compartment outwards until the lid pin is clear and then remove the lid sideways. up to up to up to up to up to up to up to up to 90 110 12 9 6 7 7 7 days days days days days days days days Note u Please note that protein-rich food deteriorates faster, i. e. [. . . ] The refrigeration increases automatically when the SuperFrost, function is activated, fresh food has just been placed in the appliance or the door has been left open for a while. The refrigeration increases automatically when the SuperCool function is activated, fresh food has just been placed in the appliance or the door has been left open for a while. As a result, adjoining units or objects are set into vibration by the running refrigeration unit. The temperature display indicates: nA The freezer temperature rose too high over the last hours or days due to a power failure or power interruption. [. . . ]