User manual LIEBHERR G 2433

[. . . ] · When disconnecting the appliance, pull on the plug, not on the cable. · Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. · Do not allow naked flames or ignition sources to enter the appliance. [. . . ] Connect the appliance with a properly earthed fused plug and socket only. Connecting to the mains SuperFrost is on Child lock is activated Alarm (symbol flashes if the temperature inside the appliance is too high) Setup mode is activated (activating the child lock and adjusting the display brightness) Demo mode is activated Adjusting the display brightness (this symbol is only activated in setup mode) Dimensions (mm) Switching on: Press the ON/OFF button so that the temperature display lights up/flashes. 3 seconds so that the temperature display goes out. Switching the appliance on and off G 20 G 24 G 27 H = 1250 mm H = 1447 mm H = 1644 mm Press the Up/Down button, the next lower temperature value in the temperature display will light up. Keep pressing the Up/Down button until the desired value is displayed. - Do not place the appliance in direct sunlight or near cookers, radiators and similar sources of heat. - Keep all food properly packed and covered so as to avoid its frosting up on the outside. - Always allow hot food to cool to room temperature before placing in the appliance. - If there is a thick layer of frost in the appliance: defrost the appliance. Accumulated dust increases the energy consumption: - Once a year, dust the refrigeration unit together with the metal grid of the heat exchanger at the back of the appliance. Note After a certain period of operation, the interior temperature will adjust to the value which has been set. Setting the temperature Saving energy Audible warning signal It sounds when it is not cold enough in the freezer compartment. The audible warning device is switched off by pressing the ALARM button. The temperature display will continue to flash until the cause of the alarm has been rectified. This can be caused by: · the freezer door being left open for a long time, allowing warm ambient air to enter; · a long power failure; · a fault in the appliance. In each case, make sure food has not thawed or perished. 9 In set-up mode you can set the child lock and adjust the brightness of the display. The child lock is designed to protect the appliance from being switched off accidentally. Additional functions Activating the child lock Press for 5 seconds. Display = Display = Display = Display = Display = Display = Adjust to the desired brightness using the Up/Down button. Display = The child lock is activated. Deactivating the child lock Press for 5 seconds. Display = The adjusted brightness will be activated after one minute. [. . . ] To speed up the defrosting process put a saucepan of hot water on the compartment floor. · Do not damage or remove the type plate on the inside of the appliance. Do not use steam cleaners because of the risk of injury and damage. If your appliance is to be shut down for any length of time, switch it off and disconnect the plug or switch off or unscrew the fuse. [. . . ]