User manual LIEBHERR G 5216

[. . . ] The same applies to changing the mains power cable. · Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated. [. . . ] - You can change the settings in increments of 1°C by briefly pressing the buttons again. - The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature in the freezer will be displayed. - The temperature can be set at between -14°C and -28°C. To reduce the temperature: Press the DOWN button. To increase the temperature: Press the UP button. - Always ensure good ventilation. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - If there is a thick layer of frost in the appliance: defrost the appliance. Accumulated dust increases the energy consumption: - Once a year, dust the refrigerating unit together with the metal grille of the heat exchanger at the back of the appliance. Saving energy Temperature display The highest temperature of the frozen food is displayed in normal operating mode. Consult the customer service department indicating the fault number displayed. Power failure "frost-control" display If nA appears in the display, this means that the freezer temperature has risen too high during the last few hours or days due to a power failure. If you press the "ALARM" button whilst the display is reading nA, the highest temperature registered during the power failure will be displayed. Check the quality of the food and its suitability for consumption in case it has become too warm or even defrosted. The highest temperature will appear for appox. The display can be switched off by repeatedly pressing the "ALARM" button. 7 Freezing Fresh food should be frozen to the core as rapidly as possible. The maximum amount of food wich can be frozen in 24 hours is shown on the type plate ("Freezing capacity . . . kg/24 hours"). This amount varies according to the model and climate rating. Notes on freezing and storage Freezing with Superfrost · For small amounts of frozen food, it is normally sufficient to switch on Superfrost 6 hours beforehand. For the maximum amount (see freezing capacity on the type plate) you will need to switch it on 24 hours beforehand. Depending on the quantity of food placed in the freezer, this will normally be between 30 and max. You should not switch on the Superfrost function: - when placing frozen food in the freezer; - when freezing up to approx. Note: The bottom two drawers are not suitable for freezing fresh food. Only pre-frozen food can be stored there. Press the Superfrost button briefly so that the LED lights up. The freezer temperature will decrease and the appliance will switch to the lowest temperature. · Always store identical food items together. [. . . ] Please note that noises caused by the refrigerant circuit cannot be avoided. · The temperature is not low enough: ­ Is the temperature setting correct (see "Setting the temperature")?­ Have excessive amounts of fresh food been placed in the appliance? [. . . ]