User manual LIEBHERR GN 3613

[. . . ] 3 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 5. 10 5. 11 6 6. 1 6. 2 6. 3 6. 4 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Insulation plate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 4 (4) onto the new hinge side tightly (4 Nm) or retighten with the aid of a cordless screwdriver if necessary. u When fitting the pressure plates, pay attention that they engage properly. u Slightly tip the appliance backwards again and reinsert the bearing pin Fig. u The safety lock (1) has to engage with the turn hinge at the side so that the bearing pin and therefore the door are secured. 580 mm), the appliance can be placed immediately next to the kitchen cabinet. The appliance projects 150 mm at the sides and 170 mm in the middle of the appliance, in relation to the front of the kitchen cabinet. - The larger the ventilation space, the more energy-saving the appliance is in operation. 8 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open. 4. 5 Disposing of packaging u Snap the safety lock (1) onto the turn hinge again. u If necessary, align the door to the appliance housing by way of the two oblong holes in the turn hinge Fig. WARNING Danger of suffocation due to packing material and plastic film!The packaging is made of recyclable materials: - corrugated board/cardboard - expanded polystyrene parts - polythene bags and sheets - polypropylene straps - nailed wooden frame with polyethylene panel* u Take the packaging material to an official collecting point. WARNING Risk of injury due to the door dropping out!If the bearing parts are not screwed into place firmly enough, the door may drop out. What is more, the door may not close and therefore the appliance may fail to cool properly. u Check all of the screws and retighten if necessary. 4. 4 Insertion into a row of kitchen units 4. 6 Connecting the appliance NOTICE Risk of damage to the electronic control system!to a. c. / three-phase) or energy saving plugs. WARNING Fire and overheating hazard!The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). Connect the appliance only with a properly installed socket outlet with earthing contact. It must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency. u Plug in the power plug. 4. 7 Switching on the appliance u Press On/Off button Fig. The temperature display and the alarm button flash until the temperature is sufficiently cold. (1) Stack cabinet (3) Kitchen cabinet (2) Appliance (4) Wall The appliance can be inserted into a row of kitchen units. 8 (2) to the height of the row of units, a suitable stack cabinet Fig. [. . . ] u Place the frozen cold storage accumulators on the frozen food in the upper front area of the freezer compartment. 6 Maintenance 6. 1 Defrosting with NoFrost The NoFrost system automatically defrosts the appliance. 8 Malfunction 6. 4 Customer service First check whether you can correct the fault yourself by reference to the list (see Malfunction). If this is not the case, please contact the customer service whose address is given in the enclosed customer service list. This noise comes from the refrigerant flowing in the refrigeru The sound is normal. The noise is produced whenever the refrigeration unit u The sound is normal. (motor) automatically switches on or off. It is briefly a little louder when the refrigeration unit (the motor) switches on. [. . . ]