User manual LIEBHERR GP 2433

[. . . ] Freezer Operating instructions 271113 7082845 - 00 GP 20. . 24. . 27 . . . 3 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 5. 10 5. 11 6 6. 1 6. 2 6. 3 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] u Check all of the screws and retighten if necessary. 6 * Depending on model and options Control 4. 4 Insertion into a row of kitchen units The packaging is made of recyclable materials: - corrugated board/cardboard - expanded polystyrene parts - polythene bags and sheets - polypropylene straps - nailed wooden frame with polyethylene panel* u Take the packaging material to an official collecting point. 4. 6 Connecting the appliance NOTICE Risk of damage to the electronic control system!to a. c. / three-phase) or energy saving plugs. WARNING Fire and overheating hazard!The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). The socket must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency. (1) Stack cabinet (2) Appliance x (3) Kitchen cabinet (4) Wall Fig. 9 For appliances supplied with wall spacers, the measurement increases by 35 mm (see 4. 2) . 9 (2) to the height of the row of units, a suitable stack cabinet Fig. depth 580 mm), the appliance can be positioned directly next to the kitchen cabinet Fig. The appliance will project by 34 mmx at the sides and 50 mmx in the centre of the appliance in relation to the kitchen cabinet front. Important for the ventilation: - At the back of the stack cabinet there has to be a ventilation duct of at least 50 mm depth throughout the width of the stack cabinet. - the larger the ventilation space, the more energy-saving the appliance is in operation. 9 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open. 4. 7 Switching on the appliance u Press the On/Off button Fig. Please contact the after sales service. 5 Control 5. 1 Brightness of the temperature display You can adjust the brightness of the temperature display to the light conditions of the room in which the appliance is installed. 5. 1. 1 Adjusting the brightness The backlight can either be switched off or set to one of 5 levels. 3 (3) shines. 4. 5 Disposing of packaging WARNING Danger of suffocation due to packing material and plastic film!u Do not allow children to play with packing material. * Depending on model and options 7 Control u Using the setting button Fig. The more display fields of the temperature display that light up, the brighter it is. w The temperature is indicated again in the temperature display. 5. 3 Temperature alarm The audible alarm sounds if the freezer temperature is not cold enough. The cause of the temperature being too high may be: - warm fresh food was placed inside - too much warm ambient air flowed in when rearranging and removing food - power failure for some time - the appliance is faulty The audible alarm is automatically silenced, the alarm symbol Fig. 3 (10) goes out and the temperature display stops flashing when the temperature is sufficiently cold again. Do not consume spoiled food. 5. 2 Child proofing The child-proofing function enables you to make sure that the appliance is not inadvertently switched off by playing children. 5. 2. 1 To activate child lock u To activate the setting mode: Press the SuperFrost button Fig. 3 (9) goes out and the temperature is displayed again in the temperature display. [. . . ] u Pull out the mains plug (not by pulling the connecting cable) or switch off the fuse. Fig. 10 7 Malfunction Your appliance is designed and manufactured for a long life span and reliable operation. If a malfunction nonetheless occurs during operation, check whether it is due to a handling 10 * Depending on model and options Decommissioning error. In this case you will have to be charged for the costs incurred, even during the warranty period. [. . . ]