User manual LIEBHERR IKP 2350 PREMIUM

[. . . ] A1, lift off cover parts 5, 6and 7 in a forward direction using a flat-blade screwdriver. A1. 1: Loosen the attachment screws 8 on the top and bottom of the body of the appliance. W Transfer the attachment screws 8 to the other side and screw in a little way. A1: Unscrew the door attachment screws 9 and replace the hinges in the diagonally opposite corner. [. . . ] W Suspend the appliance door in the ready inserted screws 8 and tighten screws. A: Fit the soft stop mechanism 3* back in place: Screw ball stud 4 together with soft stop mechanism into the new fastening hole. W Draw the fork out of the soft stop mechanism, put it over the hinge and attach with the stud. W Re-fasten with screw 3, while pressing the fork onto the hinge so that it does not disengage. W Rotate the door and closure by 180° and replace on the other side: Insert the compartment door at the top, put the hinge 1 in place at the bottom, screw down again and close the cover. Changing the compartment door GB Changing over door hinges W This appliance can also be used to replace an existing appliance. They are no longer needed as the unit door is fitted to the appliance door. The shelf and side walls of the unit must be at right-angles to one another. W The following ventilation gaps must be observed: - The depth of the ventilation channel at the rear of the unit must be at least 38 mm. - There must be a ventilation space of at least 200 cm2 underneath and at the top of the unit. B: Appliance height a, recess height b Installation information Power supply (AC) and voltage at the operating point must comply with the details on the type plate. K: bottom: loosen the hexagonal screws cs with the ring spanner co provided and adjust the door. Do not allow knobs and sealing lips to make contact with the appliance as this can have a detrimental effect on its function. W Screw plastic bracket br onto the handle side of the appliance with M5 screws bs. - Make sure the front of the plastic bracket br is flush with the front edge of the floor of the unit. Do not forget the additional space required if the unit has door furniture (knobs, sealing lips, etc. ) and align parallel to the front edge of the hinge. F1/2: Screw in with long wood board screws bu through the hinge plates at the top and bottom. F3: Screw in temporarily with a long screw bu through the middle of the long slot on the plastic bracket br. Fold up the cover on the plastic bracket and close the appliance door. G1: Check the 8 mm default setting (distance between appliance door and bottom edge of attachment strut). W Fig. L: If the unit door is large or divided into separate parts, attach another pair of attachment brackets cr (accessories bag, fig. C3). Use the pre-drilled holes in the handle area of the appliance door. [. . . ] W Check that the door is properly positioned, and readjust if necessary. L1: Tighten the counternuts dn with the ring spanner co provided, holding the adjusting pins do in position with a screwdriver. L2: If necessary, align the equaliser trim bm parallel with the floor of the unit. L3: Fix the appliance in the round hole at the bottom with the second screw bu through the plastic bracket. Fitting the unit door W Fig. [. . . ]