User manual LIEBHERR IKP 2654

[. . . ] W Take hold of cover 1 at the back for removal, bend it downwards a little and push it away to the side. W Undo screw 2, while pressing the fork of the soft stop mechanism downwards so that it cannot suddenly disengage. W Carefully disengage the fork of the soft stop mechanism from the hinge - the mechanism contracts! [. . . ] W Do not - connect to stand-alone inverters, - operate with so-called energy-saving plugs - this can damage the electronic system. - connect together with other appliances using an extension cable - danger of overheating. W When removing the mains cable from the back of the appliance, remove the cable holder to prevent vibration noise. Connecting to the mains IK/IKP/IKB/IG * Depending on model and options 5 Installation instructions Figs. D: Fit equaliser trim bm centered on the appliance: slide into the channel and engage in the key holes. W Route the mains cable with the aid of string 1 in such a way that the appliance can be easily connected after installation. W Note the thickness of the unit walls: For 16 mm unit wall (568 mm recess): - Fig. D: Stick sealing strip bp onto the side of the appliance on the handle side flush with the front: remove the protective film and stick on; shorten to recess height if necessary. E: Slide appliance into the recess until the spacers make contact with the side of the units, Fig. E2: Slide the appliance into the recess until the fronts of the hinges are flush with the sides of the unit walls; note the additional space needed for units with door furniture (knobs, sealing lips, etc. ). Press the appliance on the hinge side against the wall of the unit. Installation and fitting W Fig. J: Suspend the unit door on the door of the appliance/ adjusting pins do. J2: Align the unit door flush with the surrounding unit fronts: align laterally (X) by sliding in the corresponding direction, adjust height (Y) and lateral tilt with the adjusting pins do using a screwdriver. K: Secure the mounting bracket cr to the pre-drilled holes in the appliance door using the hexagonal screw cs. W Screw the appliance door onto the unit door with the attachment brackets cr: - Ensure that both metal edges are flush (symbol //). Drill attachment holes (making a hole with a bradawl) and screw tight. W Fig. [. . . ] H: Suspend the strut with the fitting aids dl on the inside of the unit door and align centrally (draw a short line in the middle of the unit door, align the arrow on the strut with it keeping the same distance to outer edges on left and right). H: with at least 6 screws if the doors are made of wood board, - with 4 screws round the edge in the case of panel doors. - Lift the fitting aids dl out to the top, turn round and insert into the adjacent openings. W Fig. [. . . ]