User manual LIEBHERR IKS 1614 COMFORT

[. . . ] You additionally require the following tool for installation: Screwdriver Torx®15, 20, 25, 30 Fig. A1. The door hinges can be changed from one side to the other if need be. W Unscrew hinge 4 and screw it on again at the opposite side using the same screws. [. . . ] W If the appliance has a freezer compartment, now change the compartment door. (see "Changing the compartment door") W Fit the door back in place: at the bottom place door on hinge pin 5, at the top pass hinge pin 3 through outer hole in the hinge into the door bearing and tighten. W Rotate cover parts through 180° and re-attach them to the other side. W Rotate the door and closure by 180° and replace on the other side: Insert the compartment door at the top, put the hinge 1 in place at the bottom, screw down again and close the cover. The shelf and side walls of the unit must be at right-angles to one another. W The following ventilation dimensions must be observed: - The depth of the ventilation channel at the rear of the unit must be at least 38 mm. - There must be a ventilation space of at least 200 cm2 underneath and at the top of the unit. E1, while pressing the appliance against the wall of the unit; at the bottom through adjusting screws co in the hinge 6/7, Fig. If the bearing parts have not been sufficiently tightened the doorcan tip outwards. In addition the door may not close, meaning that the appliance does not cool properly. W If necessary, align the equaliser trim bl by moving it parallel to the ceiling of the unit - it must not be proud, Fig. D3. W Depending on the height of the handle and whether the door is divided or not, fit a door connecting element bq Fig. - With the door wide open, insert the connection rails bs and screw onto the unit door. - Adjust the door connecting element so that the unit door does not make contact with the unit wall on the handle side (gap of approx. [. . . ] - Adjust the door connecting element so that the unit door does not make contact with the unit wall on the handle side (gap of approx. - If the unit door is large or divided into separate parts, attach another door connector if necessary! [. . . ]