User manual LIEBHERR K 3640

[. . . ] Upright refrigerator Operating instructions 231110 7084676 - 01 K /KP/ SKes/ SKesf . . . 3 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 6 6. 1 6. 2 6. 3 6. 4 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] u When fitting the pressure plates on the opposite side, make sure they snap properly into place. * Fig. 7 4. 3. 4 Fitting the door u Place the door from above onto the lower bearing pin u Close the door. Possibly make preliminary holes with a bradawl or use a cordless screwdriver. 5 (22). (1) Stack cabinet (3) Kitchen cabinet (2) Appliance (4) Wall When inserting the appliance into a row of kitchen units (max. depth 580 mm), the appliance can be installed directly next to the kitchen unit Fig. The appliance door projects relative to the front of the kitchen unit by 34 mm at the side and by 50 mm in the middle of the appliance. Important for the ventilation: - At the back of the stack cabinet there has to be a ventilation duct of at least 50 mm depth throughout the width of the stack cabinet. The larger the ventilation space, the more energy-saving the appliance is in operation. 8 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open. Fig. 8 4. 3. 5 Aligning the door u Align the door to the appliance housing by way of the two oblong holes in the bottom turn hinge Fig. To do so, unscrew the middle screw. WARNING Risk of injury due to the door dropping out!If the bearing parts are not screwed into place firmly enough, the door may drop out. What is more, the door may not close and therefore the appliance may fail to cool properly. u Check all of the screws and retighten if necessary. 4. 5 Disposing of packaging WARNING Danger of suffocation due to packing material and plastic film!u Do not allow children to play with packing material. 6 The packaging is made of recyclable materials: corrugated board/cardboard expanded polystyrene parts polythene bags and sheets polypropylene straps nailed wooden frame with polyethylene panel* u Take the packaging material to an official collecting point. Control 4. 6 Connecting the appliance NOTICE Risk of damage to the electronic control system!w The LED of the current temperature flashes in the temperature display. 3 (2) the number of times needed until the required temperature shines in the LED display. Note u Long pressing of the setting button sets a slightly colder value within a small temperature range (e. g. : between 5 °C and 7 °C). The LED of the next lower temperature range then shines in the temperature display. WARNING Fire and overheating hazard!The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). Connect the appliance only with a properly installed socket outlet with earthing contact. [. . . ] w This will help us to provide you with a faster and more accurate service. u Pull out the mains plug (not by pulling the connecting cable) or switch off the fuse. Fig. 13 (3). 7 Malfunction Your appliance is designed and manufactured for a long life span and reliable operation. If a malfunction nonetheless occurs during operation, check whether it is due to a handling error. [. . . ]