User manual LIEBHERR K 4270

[. . . ] Upright refrigerator Operating and installation instructions 121110 7084442 - 01 SKes/Sk/K/Kes 36. . . 42 . . . 6 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 5. 10 5. 11 6 6. 1 6. 2 6. 3 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] u Remove the protective film from the outside of the appliance. * NOTICE* The stainless steel doors are provided with a high-quality surface coating and must not be treated using the accompanying care product. u Apply a stainless steel cleaner only to the stainless steel side walls evenly, wiping with the grain. u Remove the protective film from the decorative trims. * 4. 3 Transporting the appliance CAUTION Risk of injury and danger of damage as a result of incorrect transport!u Do not transport the appliance without assistance. 6 Control u Remove all transit supports. If your appliance is not a Side-by-Side (SBS) appliance: u do not install the appliance directly alongside a further refrigerator/freezer. u Align the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustableheight feet (A) and using a spirit level. u Then support the door: Extend the adjustable foot at the turn hinge (B) until it rests on the floor and then make a further 90° turn. It must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency. u Plug in the power plug. 4. 7 Switching on the appliance u Press On/Off button Fig. w The interior light is on when the door is open. 5 Control 5. 1 Brightness of the temperature display You can adjust the brightness of the temperature display to the light conditions of the room in which the appliance is installed. When a Side-by-Side appliance (S. . . ) is fitted together with a second appliance (as a SBS combination): u Proceed according to the Side-by-Side combined fridgefreezer installation instructions. (Accessories bag of the SBS freezer/appliance with freezer compartment) Note u Clean the appliance (see 6. 1) . If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance. u Always see to good ventilation at the installation site. 5. 1. 1 Adjusting the brightness The brightness is adjustable between h0 (no illumination) and h5 (maximum luminosity). u To deactivate the setting mode: press the On/Off button -oru Wait for 5 minutes. w The temperature is indicated again in the temperature display. 4. 5 Disposing of packaging WARNING Danger of suffocation due to packing material and plastic film!3 (3). - The packaging is made of recyclable materials: corrugated board/cardboard expanded polystyrene parts polythene bags and sheets polypropylene straps nailed wooden frame with polyethylene panel* u Take the packaging material to an official collecting point. 5. 2 Child proofing The child-proofing function enables you to make sure that the appliance is not inadvertently switched off by playing children. 4. 6 Connecting the appliance NOTICE Risk of damage to the electronic control system!to a. c. / three-phase) or energy saving plugs. 5. 2. 1 Setting the child lock function u To activate the setting mode: press SuperCool button Fig. When c1 is indicated in the display: u to activate the child lock, briefly press the SuperCool button Fig. The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). Connect the appliance only with a properly installed socket outlet with earthing contact. The socket outlet must be fused with 10 A or higher. w The child lock symbol Fig. When c0 is indicated in the display: u to deactivate the child lock, briefly press the SuperCool button Fig. [. . . ] u The sound is normal. The compressor switches to a low speed when little cold is The compressor runs for a long time. u Switch off the appliance. u Attach the cover again, engage it at the right and left and pay attention that the middle hook Fig. 12 This noise comes from the refrigerant flowing in the refrigeru The sound is normal. The noise is produced whenever the refrigeration unit u The sound is normal. (motor) automatically switches on or off. [. . . ]