User manual LIEBHERR KX 102

[. . . ] Table-height refrigerator with freezer compartment Operating instructions 211211 7081874 - 02 TX 1021 . . . 1 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 2 3 3. 1 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 5 5. 1 5. 2 6 6. 1 6. 2 6. 3 6. 4 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 3 4 Putting into operation 4. 1 Transporting the appliance CAUTION Risk of injury and danger of damage as a result of incorrect transport!u Do not transport the appliance without assistance. 4. 2 Installing the appliance WARNING Fire hazard due to dampness!If live parts or the mains lead become damp this may cause short circuits. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions. to direct radiation of the sun, next to a cooker, heater and similar. q Always stand the appliance backed directly to the wall using the enclosed wall spacers (see below). q Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m2 per 8 g of R 600a refrigerant used in the appliance. If the room in which the appliance is installed is too small, a flammable gas-air mixture may form in the event of a leakage in the refrigeration circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. u Detach the connecting cable from the rear of the appliance, removing the cable holder at the same time because otherwise there will be vibratory noise!u Align the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustableheight feet (A) and using a spirit level. q The floor at the site must be flat and level. q Do not install the appliance in a location where it is exposed supplier immediately before connecting to the mains. WARNING Risk of fire due to short circuit!If the mains cable/connector of the appliance or of another appliance touch the rear of the appliance, the mains cable/ connector may be damaged by the appliance vibrations, leading to a short circuit. u Stand the appliance so that it is not touched by connectors or main cables. u Do not plug the appliance or any others into sockets located near the rear of the appliance. Note u Clean the appliance (see 6. 2) . If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance. u Always see to good ventilation at the installation site. WARNING Fire hazard due to refrigerant!u Do not damage the piping of the refrigeration circuit. 4. 3 Changing over the door hinge You can change over the door hinges if necessary. WARNING Fire hazard and danger of damage!on the appliance! q Torx® 25 q Torx® 15 q Supplied open-ended wrench q If necessary, a second person to assist with installation Make sure that the following tools are at hand: 4 Control CAUTION Risk of injury if the door tips!The middle control setting is recommended, then a middle temperature of approx. 5 °C is established in the refrigerator compartment. The temperature depends on the following factors: - the door opening frequency - the room temperature at the site where the appliance is installed - the type, temperature and quantity of frozen food u Adjust the temperature as needed, using the control. 4. 5 Connecting the appliance NOTICE Risk of damage to the electronic control system!to a. c. / three-phase) or energy saving plugs. WARNING Fire and overheating hazard!The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). [. . . ] Speed-controlled* compressors may produce varying running noise due to different speed steps. u The sound is normal. The compressor switches to a low speed when little cold is The compressor runs for a long time. u u u u u u 6. 4 Customer service First check whether you can correct the fault yourself by reference to the list (see Malfunction). If this is not the case, please contact the customer service whose address is given in the enclosed customer service list. This noise comes from the refrigerant flowing in the refrigeru The sound is normal. A quiet clicking noise. The noise is produced whenever the refrigeration unit (motor) automatically switches on or off. [. . . ]