User manual LIEBHERR WKEES 553

[. . . ] · In the event that the appliance is damaged on delivery, contact the supplier immediately before connecting to the mains. · To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions. · When disconnecting the appliance, pull on the plug, not on the cable. [. . . ] The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. · Do not connect the appliance to the supply with other equipment using an extension cable - risk of overheating. Setting up Switching on: Press the On/Off button so that the temperature display lights up/flashes. 3 seconds so that the temperature display goes out. Switching the appliance on an off Connecting to the mains Power supply (AC) and voltage at the operating point must comply with the details on the type plate, which is located inside the appliance on the left-hand side. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. Connect the appliance with a properly earthed fused plug and socket only. Setting the temperature To reduce the temperature: Press the Down button. To increase the temperature: Press the Up button. - While you are entering the temperature, the set temperature will flash on the display. - Always ensure good ventilation. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - Keep the time the appliance is open to a minimum. Saving energy - You can change the settings in increments of 1°C briefly pressing the button again. - The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature will be displayed. The temperature can be set at between +5°C and +20°C. The electronic control panel has the new "touch capacitance technology". The exact contact point is between the symbol and its label Operating and control elements Thereby a climate which corresponds to that of a wine cellar is achieved inside the appliance. Corks are prevented from drying out due to an increased level of humidity. The symbol will go out. Fan switch 3 2 6 154 Operating elements Appliance ON/OFF Temperature setting buttons Interior light ON/OFF Mute alarm Fan ON/OFF Temperature display Control elements 8 7 Interior light ON symbol Alarm symbol Child lock activated symbol Fan ON symbol bl 9 10 The audible warning signal helps to protect your wines against excessive temperatures. It sounds when the door has been left open for longer than 60 seconds. Audible warning signal The following functions can be activated in setup mode: = child lock, = display brightness Setup mode GB It sounds when the interior gets too warm or too cold. The symbol lights up. = Child lock The child lock is designed to protect the appliance from being switched off accidentally. Activating the child lock · Activate setup mode by pressing the onds. [. . . ] Turn it 90° to the left or right until it clicks into place. CAUTION! Do not store bottles crossways on the interior floor!Otherwise, bottles may fall out when the appliance door is opened and this may cause injury or material damage. 12 Defrosting The appliance defrosts automatically. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Cleaning Before cleaning always switch off the appliance. [. . . ]