User manual LIEBHERR WKEES 553 GRANDCRU

[. . . ] · Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated. · Do not stand on the plinth, drawers or doors or use them to support anything else. [. . . ] · Avoid prolonged skin contact with cold surfaces or chilled/frozen food. In the case of prolonged skin contact, protective measures should be taken, e. g. · Do not consume food which has been stored for too long, as it could cause food poisoning. · Do not store explosives or sprays using combustible propellants such as butane, propane, pentane etc. You may identify such sprays by the printed contents or a flame symbol. · If you have a lockable appliance, do not keep the key near the appliance or within reach of children. Description of appliance and equipment Operating and control elements Activated charcoal filter Pull-out shelves Type plate Remove all transportation safety components. IMPORTANT! 8 Installation dimensions (mm) Installing in a kitchen unit 1. Before installing in a kitchen unit, screw the attachment plate provided onto the appliance with screws M4 x 8). Changing over door hinges 1. Slide the appliance into the recess leaving a 21 mm gap between the body of the unit and the front face of the door. 2. Then secure the appliance with 3. 5 x 17 chipboard screws through the top bracket. 3. 9 · Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. . - The display reads · Press the button again. Down = darker , Up = brighter - The symbol will go out, indicating that the child lock is deactivated. · Exit setup mode by pressing the button. = Display brightness Adjusting the display brightness · Activate setup mode by pressing the onds. button for 5 sec- appears in the display. - The display reads · Press the 5. buttons and set the brightness between · When you reach the desired level, press the · Exit setup mode by pressing the button. 0 = minimum and 5 = maximum. button. · Close the door. The new setting will activate after about 1 minute. 11 If you are storing wine for long periods of time, it should be stored at a temperature of between 10°C and 14°C. Storing wine Equipment Pull-out grid shelves This is the temperature wine cellars are kept at, and it is just right to allow wine to mature properly. The following drinking temperatures are recommended for the various types of wine. Red wines: +14°C to +18°C Rosé wines: +10°C to +12°C White wines: +8°C to +12°C Sparkling wines, Prosecco: +7°C to +9°C Champagne: +5°C to +7°C The pull-out grid shelf allows bottles of wine to be removed more easily. Storage diagram Total: 18 bottles (for 750 ml Bordeaux bottles) Tall wine bottles can also be stored crossways on the wooden shelves. To ensure stable storage of the bottles, click the retaining plates provided onto the middle slat of the wooden shelf. Air exchange with activated charcoal filter The way in which wines continue to mature depends on the ambient conditions. Turn it 90° to the left or right until it clicks into place. CAUTION! Do not store bottles crossways on the interior floor!Otherwise, bottles may fall out when the appliance door is opened and this may cause injury or material damage. 12 Defrosting The appliance defrosts automatically. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Cleaning Before cleaning always switch off the appliance. · Clean the inside, equipment and outer walls with lukewarm water and a little detergent. [. . . ] · Ensure that no cleaning water penetrates into the electrical components or ventilation grille. · The dust should be removed from the refrigeration unit and heat exchanger - metal grid at the back of the appliance - once a year. · Do not damage or remove the type plate on the inside of the appliance. Do not use steam cleaners because of the risk of injury and damage. You may be able to rectify the following faults by checking the possible causes yourself: · Appliance does not function: ­ Is the appliance switched on? [. . . ]