User manual LIEBHERR WKES 4552 GRANDCRU

[. . . ] • The floor on which the appliance stands should be horizontal and level. Compensate for uneven floors with the adjustable feet. Setting up GB • Disconnect the appliance from the mains if any fault occurs. • When disconnecting the appliance, pull on the plug, not on the cable. • Always ensure that there is good ventilation and that the outward flowing air is able to escape. • Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. • Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance, ensure that the refrigerant circuit is not damaged. [. . . ] • If you have a lockable appliance, do not keep the key near the appliance or within reach of children. Appliance dimensions WKt 4551 WKt 5551 A = 1650 mm A = 1920 mm • The appliance is designed for use in enclosed areas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions. • The LED light strip illuminates the interior of the appliance. • When transporting or operating the appliance at an altitude of more than 1500 m above sea level, the glass pane in the door can break due to the reduction in air pressure. Broken fragments are sharp-edged and can cause serious injury. Only operate the appliance with alternating current (AC). The permissible voltage and frequency are indicated on the type plate. The position of the type plate is shown in the section entitled Description of the appliance. The tripping current of the fuse must be between 10 A and 16 A. The socket must not be situated behind the appliance and must be easily accessible. Do not connect the appliance using an extension cable or extension socket. Do not use stand-alone inverters (conversion of direct current to alternating/three-phase current) or energy-saving plugs. Risk of damage to the electronic control system! Electrical connection 13 Operating and control elements If the door is left open for more than 60 seconds, the audible warning signal will sound. Display = Display = Display = Display = Display = Use buttons and to select the desired setting. Display = h1 = minimum brightness h5 = maximum brightness Display = Display = Display = Deactivating the child lock Press for 5 seconds. Display = The adjusted brightness will be activated after one minute. Note If a button is pressed, the display lights up for one minute at maximum brightness. Display = Display = Demo mode can be activated for presenting the appliance at exhibitions or in salesrooms as though in normal operating mode. If this mode is activated by accident, it can be deactivated as detailed below. When in this mode, the cooling circuit is switched off! Demo mode Display = Display = Display = Display = The refrigeration unit switches on. The appliance is now in normal operating mode. 15 Storage diagrams for 750 ml Bordeaux bottles The storage capacity stated is only possible with the grid shelves in this configuration. WKt 5552 WKt 4552 Important The maximum load per grid shelf is 60 kg. Number of bottles WKt 5552 Number of bottles WKt 4552 18 18 39 26 39 39 39 39 39 39 40 40 Total 201 bottles 16 Total 214 bottles The interior of the appliance is lit by an LED light strip at the top of the interior container. Press the Light button if you want the interior light to be on even when the door is closed. Interior light Defrosting Cleaning GB The appliance defrosts automatically. The interior light will always switch on when the appliance door is opened. Before cleaning always switch off the appliance. Pull out the mains plug or switch off or unscrew the fuse. • Clean the inside and outer walls with lukewarm water and a little detergent. Do not use abrasive or acid cleaners or chemical solvents. • Use a glass cleaner to clean the glass surfaces and a commercially available stainless-steel cleaning agent for the stainless-steel surfaces. [. . . ] 9. Transfer door handle and plugs to the opposite side. 5. Release cover with a small screwdriver and remove. 5 10 10. Push on pressure plates until they engage. 18 GB 11 16 11 17 16. Slide cover (with the smaller opening) from outside to inside and click into place. 11. Release covers on the inside, slide them towards the outside and remove. 17. Guide cover with the larger opening over the hinge bracket, slide it from outside to inside and click into place. 12 18 13 12. Unscrew hinge bracket. 13. Unscrew closing bracket. 18. Undo adjustable foot with the spanner provided. 14 19 19. Pull hinge pin upwards and unscrew it from the adjustable foot. 20. Pull adjustable foot downwards to remove. 20 14. Re-fit closing bracket on the opposite side. 15 15. Re-fit hinge bracket on the opposite side. Insert screws in the marked openings. 22 21 21. Unscrew hinge bracket. 22. Transfer cover to the opposite side. 19 23 27. Place door on pin and move the top of it to the hinge bracket. [. . . ]