User manual LIEBHERR WTES 1753 VINIDOR

[. . . ] In the case of commercial food cooling, the pertinent statutory regulations have to be observed. The appliance is not suited for storing and cooling pharmaceuticals, blood plasma, laboratory preparations or similar substances and products subject to the Medical Devices Directive 2007/47/EC. Any misuse of the appliance may result in damage to or spoilage of the stored goods. Furthermore, the appliance is unsuited for use in areas exposed to an explosion hazard. 15 Setting up · Avoid locating the appliance it in direct sunlight or near heat sources such as an oven or a radiator. [. . . ] The type plate is located on the top left-hand side on the inside of the appliance. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. Dimensions Saving energy - Always ensure good ventilation. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - Keep the time the appliance is open to a minimum. To compensate for any unevenness, adjust the height of the feet with the open-ended wrench supplied. 16 Changing over door hinges GB Step 5 The hinge bracket at top left is supplied with the appliance. Operating and control elements Lower compartment temperature display Upper compartment temperature display Lower compartment temperature setting buttons Upper compartment temperature setting buttons Audible warning on/off button Interior light on/off button Child-proof lock On/off button Fan button 17 Switching the appliance on and off You are recommended to clean the appliance before switching it on for the first time (see "Cleaning"). The alarm will sound when the appliance is switched on for the first time and when the appliance is warm. · To switch the appliance off: Keep the "ON / OFF" button pressed for 3 sec. · To switch the appliance on: Press the "ON / OFF" button until the Display lights up. Setting the temperature The temperature of both compartments can be set separately. To reduce the temperature: Press the DOWN button; - on the left for the upper compartment, on the right for the lower compartment. - While you are entering the temperature, the set temperature will flash on the display. - You can change the settings in increments of 1°C briefly pressing the button again. - The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature will be displayed. Turn it 90° to the left or right until it clicks into place. Storage diagram for 750 ml Bordeaux bottles Total: 40 bottles 21 Defrosting The appliance defrosts automatically. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Cleaning Before cleaning always switch off the appliance. · Do not use abrasive sponges or scourers, do not use concentrated cleaning agents and never use cleaning agents containing sand, chloride or acid or chemical solvents, as these would damage the surfaces and could cause corrosion. · Use a glass cleaner to clean the glass surfaces and a commercially available stainlesssteel cleaning agent for the stainless-steel surfaces. · Clean the inside and equipment with lukewarm water and a little detergent, with the exception of the wooden trims on the grid shelves. · Ensure that no cleaning water penetrates into the electrical components. · Do not remove the type plate from the inside of the appliance; it is important for after-sales servicing. · If the motor compartment becomes dusty, it should be cleaned. To do this, remove the bottom ventilation plate as follows: 1 Remove the cover caps and screws. 2 Loosen (but do not remove) the left-hand screw on the hinge bracket. Make sure you re-tighten the screw 2 on the hinge bracket properly. 22 Malfunctions GB Your appliance is designed and manufactured for a lengthy, reliable operating life with no malfunctions. [. . . ] · The temperature inside your wine cooler is too warm: Check the setting in accordance with the section "Setting the temperature". · Please note that, as can happen with other forms of storage, slight mould may form depending on the type of adhesive on the labels. This can be rectified by carefully cleaning any adhesive residues off the bottles. If none of the above causes apply and you cannot rectify the fault yourself, contact the nearest customer service department stating the type of appliance, servicenumber and appliance number as indicated on the type plate. [. . . ]