User manual LIEBHERR WTUES 1653 VINIDOR

[. . . ] 18 Additional functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Audible warning signal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Interior light. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Equipment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] You can compensate for an uneven floor by adjusting the adjustable feet. · Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. · The appliance is set to operate within specific ambient temperature limits according to its climate rating. The correct climate rating for your appliance is indicated on the type plate. SN = +10°C to +32°C SN - ST = +10°C to +38°C Electrical requirement Power supply (AC) and voltage at the operating point must comply with the details on the type plate. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. Fitting dimensions (mm) Installation and fitting · Adjust to recess height using the 4 adjustable feet on the underside of the appliance. · Connect the appliance to the mains. · Secure the appliance in the recess using 4 x 14 screws. The ventilation cross-section in the plinth panel must be min. 300 cm². 16 Changing over door hinges GB Operating and control elements Lower compartment temperature display Upper compartment temperature display Lower compartment temperature setting buttons Upper compartment temperature setting buttons Audible warning on/off button Interior light on/off button Child-proof lock On/off button Fan button 17 Switching the appliance on and off You are recommended to clean the appliance before switching it on for the first time (see "Cleaning"). The alarm will sound when the appliance is switched on for the first time and when the appliance is warm. · To switch the appliance off: Keep the "ON / OFF" button pressed for 3 sec. · Press and hold the "Light" button and at the same time press the temperature setting buttons for the lower compartment to increase or decrease the brightness. "Down" = darker, "UP" = brighter. Equipment Pull-out shelf Labels The pull-out shelf allows bottles of wine to be removed more easily. The appliance is supplied with a label holder with labels for each shelf. Use a soft pencil on the labels so that you can erase it again when necessary. Fitting: Click the label holder into place and slide the label in from the side. 20 Air exchange with activated carbon filter GB The way in which wines continue to mature depends on the ambient conditions. For this reason, an activated charcoal filter is fitted in the interior rear wall of both the upper and lower compartments. Turn it 90° to the left or right until it clicks into place. Safety lock The lock in the appliance door is equipped with a safety mechanism. To unlock the appliance, the same procedure must be repeated in the same order. Turn the key clockwise. Storage diagram for 750 ml Bordeaux bottles Total: 38 bottles 21 Defrosting The appliance defrosts automatically. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Cleaning Before cleaning always switch off the appliance. · Do not use abrasive sponges or scourers, do not use concentrated cleaning agents and never use cleaning agents containing sand, chloride or acid or chemical solvents, as these would damage the surfaces and could cause corrosion. · Use a glass cleaner to clean the glass surfaces and a commercially available stainlesssteel cleaning agent for the stainless-steel surfaces. [. . . ] · Please note that, as can happen with other forms of storage, slight mould may form depending on the type of adhesive on the labels. This can be rectified by carefully cleaning any adhesive residues off the bottles. If none of the above causes apply and you cannot rectify the fault yourself, contact the nearest customer service department stating the type of appliance, service number and appliance number as indicated on the type plate. The type plate is located on the left-hand inside wall. 23 Safety instructions and warnings · To prevent injury or damage to the unit, the appliance should be unpacked and set up by two people. [. . . ]