User manual LIFT-MASTER 98LM

[. . . ] INSTALLATION The door control is typically attached directly to the wall. For pre-wired installations (as in new home construction) it can be mounted to a standard single gang box. If installing the door control adjacent to existing door controls be sure the detector switch is accessible. [. . . ] Replace the cover by inserting the top tabs and snapping it into place. Test the wall control to ensure proper operation. LOCK LIGHT Model 98LM Motion Detecting Door Control Panel WARNING OWNERS INSTRUCTIONS CAUTION WARNING To prevent possible SERIOUS INJURY or DEATH from electrocution: · Be sure power is not connected BEFORE installing door control. To prevent possible SERIOUS INJURY or DEATH from a closing garage door: · Install door control within sight of garage door, out of reach of children at a minimum height of 5 feet (1. 52 m), and away from all moving parts of door. · NEVER permit children to operate or play with door control push buttons or remote control transmitters. · Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. NEVER permit anyone to cross path of closing garage door. STANDARD WALL MOUNT To Replace Insert Top Tabs First PRE-WIRED INSTALLATION 24 Volt 2-Conductor Bell Wire To Replace Insert Top Tabs First LOCK Push Bar Cover LIGHT Detector Switch ON OFF LOCK Push Bar Cover LIGHT Detector Switch ON OFF Figure 1 2-Conductor Bell Wire 2 W HT Push Bar Quick-Connect Terminals 1 RED Door Control Terminal Lock Screws Button LOCK LIGHT Light Button Door Control Connections Strip wire 7/16" 7/16" (11 mm) To release wire, push in tab with screwdriver tip Antenna Red White Grey OR Figure 2 Opener Terminal Screws 2-Conductor Push Bar Bell Wire 2 W HT 1 RED NOTE: The automatic light feature will become functional 6-1/2 minutes after power is restored. Door Control Terminal Screws LOCK LIGHT Lock Light Button Button Opener Panel Antenna OPERATION Door Control Push Bar: Press to open or close the door. Press again to reverse the door during the closing cycle, or to stop the door while it is opening. Light Feature: Press the Light button to switch the opener light on or off. When the door is opened or closed, the light will remain on for 4-1/2 minutes. The Light button will not control the opener light when the door is in motion. When using the opener lights as working lights, we recommend that you first disable the motion sensor. When used with openers manufactured after December 1, 1999, (check the date on the opener panel) the 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc. , up to a maximum of four blinks and 4-1/2 minutes. Automatic Light Feature: The opener light will turn on automatically when a person enters the garage. When a person walks in front of the door control, the opener light will come on for five minutes, then shut off. [. . . ] Use a small screwdriver to turn the dial by 1/4 turns: counterclockwise to make the light come on, or clockwise to make the light go off. Lock Feature: Designed to prevent operation of the door from portable remote controls. However, the door will open and close from the Door Control push bar and from the Keylock and Keyless Entry accessories. [. . . ]