User manual LIFT-MASTER R900

[. . . ] Robo Swing R900TM / Robo SlideTM surge suppression installation manual Please read this entire manual before installation Important! Possible Damage 50 ft ROBO SURGE SUPPRESSOR P/N Q412 PATENT PENDING The green ground wire must be securely connected to the chassis Note: Plate For Use with Roboswing Only! ACCESS SYSTEMS INC Safe + POWER INPUT 18 VAC SAFETY LOOP EXIT LOOP FIRE DEPT STRIKE OPEN KEY SWITCH PUSH BUTTON RADIO RECEIVER CLASS 2 SUPPLY 50 ft Inputs protected by the Surge Protection Module. [. . . ] All Rights Reserved For Technical Support: 1-800-528-2806 TM 845 Larch Avenue Elmhurst, Illinois 60126 www. chamberlain. com W1 CHECK CHARGING FUSE BOARD POWER POWER SYSTEM ON J2 ALARM SENSOR REVERSE SENSOR OVERLOAD POWER CHARGE OK BATTERY LOW OPEN RELAY CLOSE RELAY HEAVY GATE DC OPERATOR v 5M MADE IN USA CENTRAL CONTROL FIRE DEPT STRIKE OPEN TIMER ON UP PW SAFETY LOOP 60 OFF 0 EXIT LOOP RADIO REC OPEN TO RIGHT W1 Robo SlideTM Surge Suppressor Step-by-Step Installation STEP 1 STEP 2 Unplug the power transformer, battery connection and all accessory wires from terminal block. CAUTION! gate catch post warning Disconnect yellow power transformer wires from J1 plug. STEP 3 STEP 4 Radio Receiver + Unplug the J1 socket and remove the old terminal block. Mount surge suppressor in same place as old terminal block. STEP 5 Connect green ground wire to the chassis. DO NOT USE METAL PLATE STEP 6 Plug the surge suppressor's J1 plug into control board and reconnect battery. Plug transformer back in. Test all the accessories in combination with the gate operator to corroborate proper installation and functionality. For Technical Support: 1-800-528-2806 ® TM J2 1. 5A - 250V Robo Swing R900TM Surge Suppressor Step-by-Step Installation STEP 1 STEP 2 Unplug the power transformer, battery connection and all accessory wires from terminal block. 1. 5A - 250V Disconnect power transformer wires from J1 plug. STEP 3 STEP 4 Unplug the J1 socket and remove the old terminal block. STEP 5 Carefully break off the 2 studs that held the old terminal block. DO NOT use hammer! STEP 6 Remove the two lower screws holding electronic box to chassis and mount the surge suppressor with plate in the electronic box with the two screws. Make Sure Green Ground Wire Makes Good Contact With Chassis. Plug the surge suppressor's J1 plug into control board and reconnect battery. STEP 7 Test all the accessories in combination with the gate operator to corroborate proper installation and functionality. For Technical Support: 1-800-528-2806 Reconnect all accessory and power wires to surge suppressor module. [. . . ] All Rights Reserved TM 845 Larch Avenue Elmhurst, Illinois 60126 www. chamberlain. com [. . . ]