User manual MAGIMIX EXPERT & MILK 11380

[. . . ] €• If the bottom part of the Aeroccino is wet, dry it before putting it back in contact with the plug.  Remove the water tank and capsule container to clean them (see cleaning section).  Place the water tank on its base and place the drip tray and the capsule container in position. placez le réservoir d’eau sur sa base , puis insérez le bac d’égouttage et le bac à capsules. [. . . ] CAUTION: In case base needs to be cleaned unplug it first and use only a damp cloth. CAUTION: If the bottom part of the jug is wet, dry it before putting it back in contact with the plug. Do not use abrasives, sharp objects, brushes: risk of scratches and harm to the jug coating. 21 EN FR Entering the settings mode / Accès au mode réglage To enter a settings mode: - Ensure machine is OFF and slider is closed. To exit settings mode: -  he machine goes back to stand-by mode automatically after 30 seconds. can now program another auto OFF mode: You 9 minutes 30 minutes 2 hours 8 hours The selected icon will blink twice to confirm change has been made and then the machine will turn OFF. 22 Programming the water volume /  Programmation du volume d’eau Any coffee button can be programmed: Ristretto: from 15 to 30 ml Espresso: from 30 to 70 ml Lungo: from 70 to 130 ml Americano: coffee from 15 to 110 ml, hot water from 25 to 300 ml Hot water from 50 to 300 ml o program Ristretto, Espresso and Lungo volumes: T 1. Select Americano recipe and press and hold brewing button until desired coffee volume is reached. Press and hold again and keep pressed until desired water volume is reached. EN FR 23 EN FR Settings mode: Reset to Factory Settings /  Mode réglage: restauration des réglages par défaut If you reset to factory settings, this will cancel the pairing and capsule stock management and reset the water hardness level. -  ress brewing button for 6 seconds - both dials will flash to confirm you are in settings mode. T -  o exit this mode without doing a factory reset, push the brewing button. No / Exit: T Yes / Confirm: -  o factory reset, turn temperature dial up to maximum position and press brewing button. > 6 sec ❸ nter settings mode: E - Press brewing button for 6 seconds - both dials will flash to confirm you are in settings mode. - Select Espresso and press brewing button - Espresso icon flashes for confirmation. - To exit this mode without doing a factory reset, push the brewing button. No / Exit: Yes / Confirm: - To factory reset, turn temperature dial up to maximum position and press brewing button. - When the procedure is finished, clean the drip tray and the cup support. 25 EN FR Cleaning / Nettoyage To ensure hygienic conditions, it is highly recommended to empty and clean the used capsule container every day. par mesure d’hygiène , il est fortement recommandé de vider et de nettoyer quotidiennement le bac à capsules usagées.  Remove lid and water tank and clean them all with odorless detergent and rinse with warm / hot water. Dry all water tank container parts with a fresh and clean towel, cloth or paper and reassemble all parts. [. . . ] Your appliance contains valuable materials that can be recovered or can be recycled. Separation of the remaining waste materials into different types facilitates the recycling of valuable raw materials. Should your machine have a genuine manufacturing fault, you must return it to the retailer within 28 days of purchase. Your machine is guaranteed for 3 years for parts and labour from the date of purchase. [. . . ]