User manual MAGIMIX NESPRESSO M300

[. . . ] Keep the machine and the electrical cord out of children's reach. The cord or any other defective element must be replaced exclusively by an authorized after-sales service centre. Equally included are 4 varieties of Nespresso coffee (4 x 10 capsules) allowing you to use the machine immediately. For further information concerning the different varieties of Nespresso coffee and to order capsules, contact your Nespresso Club at the address found on your machine or in the «Welcome-pack». [. . . ] Once you have programmed the water hardness the level will stay memorised ­ even if the machine is disconnected from the mains. Displaying the number of cups Press the key /P until the word CUPS appears on the display. Release the key and the number of cups now appears on the flashing display. Descaled display Press the key /P until DECALC appears on the display. Release the key and the number of descaling operations effected flashes on the display. Access to the programming mode To access the programming mode, the machine must be connected to the power supply. Setting the language Press the key /P until LANGUAGE appears on the display. Press the key /«+» or /«-» to access this programming point. Now press the key /«+» or /«-» until the desired language appears. TAP CLOSE When you draw off warm water to reduce the steam temperature, this message is displayed after the machine has automatically interrupted the process of drawing off water. This message appears when the cup filling quantity is being programmed. - Clean the capsule holder as described under «Cleaning» - Press the key or with the capsule holder inserted but without coffee capsules; When READY is displayed on the display you can prepare your coffee normally. If the message does not disappear - clean the needle cage as described under «Cleaning». Replace the capsule holder on the capsule cage and tighten until the handle is facing you or slightly offset towards the right Place the preheated cup (see «preheating cups») under the «coffee» outlet Depending on the choice of cup, (large or small), press or (11). 0 dl of coffee The machine stops automatically when the desired filling level is reached. Remove the full cup, remove the capsule holder and the used capsule (12) You can reduce the filling quantities set in the factory or those you have programmed yourself by briefly pressing either of the keys or before the automatic cutout occurs. Note: if a power failure occurs, the values set in the factory and those programmed by you are memorized. WAIT The machine has not yet reached the necessary operating temperature. eNGLISH READY The machine has reached the necessary operating temperature. WATER Displayed when water is being drawn off LARGE Displayed when a large cup is being filled SMALL Displayed when a small cup is being filled WAIT STEAM You have pressed the steam key. TOO HOT This message is displayed when you wish to serve coffee immediately after preparing steam without the temperature having fallen. To ensure that the quality of your next cup of espresso is ideal, replace the empty capsule holder on the capsule cage to retain the heat. [. . . ] Your Nespresso Club will provide you a descaling kit including specific products and Instructions for descaling your machine. Note: when STEAM READY appears on the display but you do not draw steam off for three minutes, the display display changes and TOO HOT appears. Either run hot tap water through it or simply insert the empty capsule holder in the spout ring and let water run through it while slightly loosening and re-tightening the capsuleholder to vary the pressure flow. You can also descale your machine before the message appears : - Turn off the machine, then press the steam switch (9) (approx. [. . . ]