User manual MCINTOSH MCD7007

[. . . ] IMPORTANT SAFETY INSTRUCTIONS THESE INSTRUCTIONS ARE TO PROTECT YOU AND THE MclNTOSH INSTRUMENT. Read all instructions - Read the safety and operating instructions before operating the instrument. 2. Retain Instructions - Retain the safety and operating instructions for future reference. 3. WARNING: TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS INSTRUMENT TO RAIN OR MOISTURE. Power Sources - Connect the power supply only to the type described in the operating instructions or as marked on the unit. [. . . ] After reading the contents list, the MCD 7007 switches to stand-by mode ready for further instructions. If the light remains on and the disc refuses to play, make sure that the disc is properly in the drawer and label side is up. After the contents list on the disc has been read, the number of tracks on the disc will be displayed on the track indicator. When play begins, elapse playing time is displayed and the eLAPsed indicator lights. To go back to the beginning of a track while it is playing, touch PLAY. When all the tracks have been played, the track indicator, the total elapsed time and the DAMAGED DISC/MUTE indicator will light. Volume may be adjusted by using the VOLUME or VOLUME on the front panel or on the remote control. Adjustment of the volume is performed by an electronically switched precision ladder attenuator. The Mclntosh electronic precision ladder attenuator adjusts volume by C2 MOS transistor switches that select the right combinations of highly accurate deposits of resistive material for the volume programmed. Because there aren't any moving parts, the volume adjustment cannot generate noise or misalignment. As volume is increased, more segments are lighted to indicate relative volume. The first 10 seconds of each track will be played when the SCAN button is used to initiate play. As each track is previewed the SCAN indicator, the TRACK number and the eLAPsed TIME is displayed. When the tracks have been previewed, the SCAN indicator turns off, the laser pick-up returns to the beginning of the first track. The total number of tracks and the total time will be displayed in the message center. If, before you have previewed all tracks, you decide to listen to all of the remaining tracks on the disc, touch PLAY. The SCAN indicator will go off and the remaining tracks will play in their entirety, beginning with the track indicated in the message center. Any track can be entered in the memory for later playing while using SCAN. To enter a track, touch STORE while the track is playing and the TRACK will be inserted in the memory. The player will preview the next track and the indicator for that track will be displayed. To listen to the stored program, touch PLAY And the disc will play the stored tracks in the sequence selected. OPERATION 9 MESSAGE CENTER DISPLAY-5. Disc symbol flashes during loading and starting Play is in continuous loop between selected points A (start) and B (end). PAUSE function is active. REPEAT function is active. Track or index symbols flash during programming. Minutes or Seconds symbols flash during programming. Indicates REMaining Total Time or eLAPsed Track Time. Indicates Relative volume level Indicates program has been stored. [. . . ] After touching LOAD, PLAY or SCAN, the disc drawer does not slide in. · The 120 VAC supply has been disconnected and the track indicator will not light. Touch STOP and then touch LOAD, PLAY or SCAN again to see if the drawer closes. If a disc is in position, remove it, than push the drawer in carefully to close it. 4. After closing the drawer the Message Center Data shows the 'OoOoo' and the DISC and ERROR light and nothing further happens. clean disc. [. . . ]