User manual MELITTA EXPRESSO CAFFEO PASSIONE

[. . . ] Danger due to electrical current If the appliance or the power cable is damaged, the risk of a fatal electric shock is run. Observe the following safety instructions to avoid dangers due to electrical current: – Do not use a damaged power cable. € A damaged power cable may only be replaced by the manufacturer, its customer service or a similarly qualified person. € Only use the appliance when it is in a technically flawless condition. [. . . ] In doing so, ensure that the tip of the steam pipe is immersed in the water. € Wait for 30 seconds or press the button to change to the normal operating mode. 2015 21:01:00 EN Preparing milk froth and heating milk and water Heating milk • Switch on the appliance. Dispensing hot water A maximum of 150 ml of hot water can be dispensed in each process. € Push the outer shell of the steam pipe up in the direction shown by the arrow (Image K, 2). € Empty the drip tray and insert without the coffee grounds container. € Screw the water filter onto the thread at the bottom of the water reservoir. Is illuminated on the • When display, turn the valve switch 11 counterclockwise until the stop. After inserting the water filter, the water can be cloudy during the first rinse because excess activated carbon is washed out of the filter. Water hardness and filter It is important to properly set the water hardness so that the appliance displays the need to be descaled in due time. After inserting a Melitta® Claris® water filter, it is automatically set at hardness level 1. The cleaning programme should be performed every 2 months or after 200 brewed cups, however, at the latest when is flashing. And buttons • Press the simultaneously for longer than 2 seconds. € Insert the drip tray without the coffee grounds container • Place the coffee grounds container under outlet 2. Is illuminated, empty the drip • When tray and the coffee grounds container is and reinsert them. € Insert the water filter if necessary („Water hardness and filter“, page 22). 2015 21:01:01 Other settings Energy-saving mode After the last action, the appliance switches automatically (depending on the settings) to the energy-saving mode. And • Press the simultaneously until • Press the illuminates. Display Time 30 minutes (factory setting) 2 hours 4 hours flashing 8 hours button twice. And • Press the simultaneously until • Press the illuminates. Button to confirm the Auto-OFF function The appliance switches off automatically after the last action (depending on the setting). And • Press the simultaneously until • Press the illuminates. [. . . ] Switch off the appliance and switch it on again via the ON/OFF button ; if this does not solve the problem send the appliance to the service department. For • Tryk på tænd/sluk-knappen at tænde eller slukke for maskinen. Direktivet forskriver rammerne for en tilbagetagelse og genanvendelse af brugt udstyr, der gælder inden for hele EU. Sluk for maskinen, og tænd for den igen på tænd/sluk-knappen Bryggekammeret er overfyldt. [. . . ]