User manual MIELE NOVOTRONIC T230C

[. . . ] Operating instructions for condenser tumble dryer T 230 C To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed or used for the first time. Com manuals search engine Warning and Safety instructions Technical safety To avoid the risk of accidents and damage to the machine please read these instructions carefully before using it for the first time. They contain important information on its safety, installation, use and maintenance. Keep these instructions in a safe place and ensure that new users are familiar with the content. [. . . ] ^ The drum and other stainless steel parts can be cleaned with a suitable proprietary stainless steel cleaner following the manufacturer's instructions. do not use solvents , abrasive cleaners , glass cleaners or allpurpose cleaners. ^ A microfibre E-Cloth is available from the Miele UK Spare Parts Department which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. ^ To remove the filters in the door opening, grip the holder and push upwards in the direction of the arrow to remove it. ^ Push the large filter back into the door holder until it clicks into position. Com manuals search engine Cleaning and care Cleaning the condenser unit Detergent residue, hair and fine fluff from the dryer can get through the fluff filters and block the condenser unit. Dust from the room in which the dryer is installed can also get into the condenser unit and cause a blockage. If the dryer is used frequently then clean the condenser unit after approx. Removing the condenser unit ^ Turn the lever on the inner cover downwards to the vertical position. ^ Pull the cover forwards ^ Then remove it by pulling it diagonally upwards. ^ Open the service panel by pressing the two lower corners at the same time (see illustration). Com manuals search engine Cleaning and care If you cannot see any fluff: ^ Replace the condenser unit (see following page). If you can see some fluff: ^ Clean the condenser unit as described below. Cleaning the condenser unit ^ When rinsing the condenser unit, make sure you position it as shown in the next two illustrations. Checking the condenser unit ^ Use a shower head or similar to rinse the unit out as shown. Com manuals search engine Cleaning and care Replacing the condenser unit ^ With the handle facing upwards, push the condenser unit back into position in its housing. ^ Turn the lever down to the horizontal position, making sure that the hook on the lever clicks into the groove. When replacing the inner cover after cleaning, ensure that the rubber seal fits correctly into the groove. ^ Then turn the lever upwards into the horizontal position to lock the cover. ^ Replace the service panel and press the upper edge until it clicks into position. It is important to ensure that both the condenser unit and the cover are correctly positioned and locked. ^ Check the condenser unit again for any visible fluff and if necessary flush it through again until it has all gone. [. . . ] Before you begin, first ensure that: – The tumble dryer is switched off. A Press the Start button and keep it pressed in whilst carrying out steps B to C. €“ If the Drying indicator lamp is not on, the increased drying level is deactivated. €“ If the Drying indicator lamp is flashing, the increased drying level is activated. [. . . ]