User manual MINOURA BIKE PIT

[. . . ] Most parts are made of light alloy so the completed weight of the Bike Tower is only 3 kgs, therefore your can move it anywhere you want easily and its simple design can fit everywhere. IMPORTANT NOTES · Please read this instructions manual carefully before use. · Bike Tower is the display stand for ordinary 2-wheel bicycles only. Do NOT use it for any other purpose, for example, for displaying heaviy electric bikes or tandem bikes. [. . . ] · Bike Tower is installed between the floor and ceiling using a strong spring and the tension this provides. Bike Tower MUST be installed firmly on a a solid floor and ceiling using a supporting beam or load bearing area of the ceiling. Failure to do so may cause damage to your ceiling, bikes, Bike Tower, and may cause personal injury. ! Set the Bike Tower up vertically from floor to ceiling. Slanted installation may cause the Bike Tower to fall down, causing damage and/or injury. X ! Set Bike Tower firmly against a supporting beam or load bearing area of the ceiling. Failure to do so will cause damage to your ceiling. ceiling supporting beam ! When setting the main telescoping pole, make sure to extend it until the red warning sign no longer shows. -1Red Warning Sign HOW TO SETUP BIKE PIT We explain the name of each part as below; Required tool : 5mm hex wrench (included) Upper Rubber Cup Lower Support Angle Adjust Plate (projection is foreside) Height range: 1. 6m (5'3") - 3. 1m (10'2") Upper Pole Pole Joint Alloy Stay Frame Hook Lower Pole Bottom Rubber Cup 1 Loosen the upper bolt on the Pole Joint then extend the main pole. After you fit the main pole to the ceiling, tighten the bolt slightly. A) Tighten temporaly 2 Remove the main pole, making sure the pole length is not changed. Please start the installation process over again to insure proper set up and that the red warning label does not appear. 2 (Fig. G) ! Make sure the Bike Tower is set up vertically with no slant. If you want to move the cradle, loosend the lower bolt on the angle adjust plate, change the angle until the displayed bike will be horizontally as much as possible then tighten the bolt again. H) HOW TO USE BIKE PIT Bike Tower can stand alone, but we recommend it is set-up next to a wall for increased safety. If the bicycle does not have a standard frame design, it should be supported by the top tube and rear seatstay configuration. I) BIKE PIT USE CHECK LIST You must check the following points before use; 1. Check to make sure the main pole is not bent or developing any rust. WHY MY NUT IS MISALIGNED? The inside nut of the stainless band clamp is not square, it is rectanle. You have to remove the stainless band to wind up it around the pole for assembling. [. . . ] Check to make sure the main pole is not bent or developing any rust. WHY MY NUT IS MISALIGNED? The inside nut of the stainless band clamp is not square, it is rectanle. You have to remove the stainless band to wind up it around the pole for assembling. If you had removed the nut, make sure the nut direction that the longer side must be vertical. [. . . ]