User manual MOTOROLA DSR315

[. . . ] DSR315 User Guide This user guide is for use with DSR315 Digital Satellite Receivers Publication #494862-001 Rev D All Rights Reserved General Instrument Corporation doing business as the Broadband Communications Sector of Motorola, Inc. San Diego, California 92121 Internet: http//www. mot. com Copyright © 2004 Motorola, Inc. No part of this publication may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation or adaptation) without written permission from Motorola, Inc. Motorola reserves the right to revise this publication and to make changes in content from time to time without obligation on the part of Motorola to provide notification of such revision or change. [. . . ] The Channel Information option allows you to turn the header (top of screen) and banner (bottom of screen) On or Off. The Subtitles option allows you to select the language for subtitles (if available for the particular program) or keep them turned off. The Language option allows you to select the language of the onscreen menus and audio for your programs. The TV Viewing option allows you to select the size of the viewing area. Select the Standard option if your TV screen is a typical screen with a 4:3 ratio of width to height. Select Wide if your TV screen is a wide screen with a 16:9 ratio (as in HDTV's or digital TV's). The default setting is Standard. Audio Settings If you are in SAT mode (digital) broadcast, two options appear on the Audio Settings menu. Select option 1 (Audio Connections), and you will be able to select either TV or HiFi (the default is TV). Select TV if the receiver's AUDIO OUT port is connected to your TV. Select HiFi if it is connected to your stereo system. DSR315 User Guide 23 3 Satellite Audio. Select option 2 and then select Mono, Stereo, Surround or Dolby Digital (the default is Surround). The Dolby Digital selection will disable other audio ports. Installation Settings Tune in Satellite Signal. This option allows you to see the strength of the signal your antenna is receiving. This option allows you to control up to four receivers in a centralized area, with one or more remote controls. On the front panel of your receiver press the Menu button to bring up the Menu screen. On the Installation Settings menu, choose option 2 (Set Remote Control Address). If you have four receivers, you will have to change the addresses on three of them: they will have address of 0000, 0001, 0002, and 0003. To program your remote control for each receiver, hold down the SAT key on the remote control until the light flashes. Once the light begins to flash enter the desired address. 24 Installation System Status This is a view-only screen that displays information about the status of the receiver. Trip Counter displays the number of message updates from your service provider. Displays a number of messages that describe the current modem status. Caller ID When your telephone rings the Caller ID feature allows you to see who may be calling. This feature is only available if Caller ID functionality is enabled by your telephone company. See the "Options" section for more detailed information. Authorization Screens Sometimes when you tune to a program, an Authorization screen will appear. [. . . ] The name you enter will override the name, if any, that has been provided by the telephone company. You can enter up to 20 names to be associated with 20 different calling telephone numbers. This option is used for entering the name that is to be displayed when being called from the specified telephone number. Choose option 2, use the channel up/down buttons to scroll through the available characters, both upper case and lower case letters are available as well as numbers, spaces and various other characters. [. . . ]