User manual MOTOROLA H390

[. . . ] When the headset's battery is fully charged (about 2 hours), the indicator light turns green. 2 Scroll to Power. The Bluetooth feature remains on until you turn the feature off. Note: These steps are for most Motorola phones. For other phones, see your phone's user's guide. 3 Disconnect the charger. Note: Headset is not functional while charging. [. . . ] 2 On the phone, dial the number you want to call and press SEND key on your phone. If your phone and headset are successfully paired, you will hear ringing on the headset. After you have successfully paired your phone and headset, you don't need to repeat these steps. For daily use, ensure that your headset is turned ON and that your phone's Bluetooth feature is ON. Note: If desired, your headset can be restored to original factory settings. This action will erase all pairing information stored in your headset. Thus, you will need to pair your phone and headset again (see step 3). Note: To restore your headset to original factory settings, press and hold both Volume buttons and the Call button at the same time for 10 seconds. TROUBLESHOOTING My headset will not enter pairing mode. Make sure that any devices previously paired with the headset are turned off. If the indicator light is not steadily lit in blue, turn off both the other device and headset, wait 10 seconds, then turn headset back on. Wait for the indicator light to become steadily lit in blue, indicating the headset is now in pairing mode. Make sure the indicator light on your headset is on (lit in blue) and steady when your phone is searching for devices (see step 3). Make sure your phone is on and the Bluetooth feature is turned on in your phone (see step 2). If the Bluetooth feature was turned off or was turned on only temporarily, you may need to restart the Bluetooth feature (see step 2) and pair your phone and headset again (see step 3). If you need more help, contact us at 1-877-MOTOBLU or visit us at www. motorola. com/Bluetoothsupport Features and Functions Guide H390 Bluetooth® Handsfree Headset TURNING HEADSET ON AND OFF To turn your headset on, slide the switch toward the microphone. The indicator light flashes blue three times, then flashes in blue and purple (if connected with a device) or is steadily blue (if ready to be paired). The indicator light flashes three times then turns off. IMPORTANT: Be sure to first follow the Quick Start Guide on the reverse side of this guide to complete initial setup of your H390. Indicator Light Power Switch EARBUDS AND YOUR HEADSET Your H390 headset is supplied with multiple earbuds. [. . . ] To find your DoC, enter the product Approval Number from your product's label in the "Search" bar on the web site. To save battery power, turn OFF the headset when you don't use it for an extended time by sliding the switch towards the charging plug. Note: Your battery is designed to last the life of the product. ANY ATTEMPT TO REMOVE OR REPLACE YOUR BATTERY WILL DAMAGE THE PRODUCT. MAKING CALLS Function Receive a call Mute or unmute a call Action Tap the Call button Tap both Volume buttons Reject a call Press and hold a Volume button until the ringer stops End a call Tap the Call button Redial last call Press and hold the Call button until you hear two tones Make a voice dial call Tap the Call button and wait for voice prompt Answer second incoming Use phone to answer call (follow your phone's instructions) Note: Your H390 supports both Handsfree and Headset Profiles. Accessing call functions depends upon which profile your phone supports. [. . . ]