User manual MOTOROLA T5710

[. . . ] @6881042B60@ 6881042B60-A Models T5600, T5620, T5700, T5710, T5720 Introduction Congratulations on your purchase of a Motorola product!Registering helps us facilitate warranty service and permits us to contact you should your Motorola product require an update or other service. To register your product on-line, visit www. motorola. com/warranty/radios. For warranty service of your Motorola product, you will need to provide a copy of your dated sales receipt to confirm warranty status. [. . . ] If the cord is damaged, call Motorola Product Services at 1-800-353-2729 in the USA or 1-888-390-6456 TTY (Text Telephone). 10 FCC Licensing Information Your Motorola radio operates on General Mobile Radio Service (GMRS) frequencies and is subject to the Rules and Regulations of the Federal Communications Commission (FCC). With the back of the radio facing you, lift the battery latch up to release the battery cover and remove the cover. Insert 3 AA Alkaline batteries as shown on the inside of the battery compartment. Note: The T5600, T5620, T5700, T5710, and T5720 model radios can use a NiCd rechargeable battery instead of 3 AA Alkaline batteries. A rechargeable battery upgrade kit, model number 53614, is available for these radios. For the dealer nearest you, call 1-800-353-2729 in the USA, or visit our website at www. motorola. com/talkabout. Installing the NiCd Battery Pack 1. Insert the NiCd battery pack so the metal contacts on the side of the battery are facing outward from the radio to connect with the contacts on the battery door. 14 Getting Started Battery Meter The battery icon shows the battery charge level, from full d to empty a. When the battery is empty, the radio chirps periodically after releasing M. The radio powers off when the voltage drops below a predetermined level to protect the rechargeable battery. Getting Started 15 Note: Remove the batteries before storing your radio for extended periods of time. Batteries corrode over time and may cause permanent damage to your radio. Using the Desk Stand Charger (Optional Accessory) The desk stand charger provides drop-in charging convenience for NiCd batteries and can be placed on any flat surface, such as a desk or workbench. Charge the NiCd battery overnight (at least 16 hours) before using it for the first time. After the initial charge, an empty battery is fully charged within 14 hours. Insert the NiCd battery pack so the metal contacts on the side of the battery are facing outward from the radio to connect with the contacts on the battery door. To charge the battery pack separately from the radio: Getting Started 16 1. Make sure the metal contacts on the side of the battery are making contact with the contacts inside the charger. Notes · · When moving between hot and cold temperatures, do not charge the battery until the battery temperature acclimates (usually about 20 minutes). For optimal battery life, remove the radio or battery from the charger within 16 hours. Push down on the release tab at the top of the belt clip to release the catch. Turning Your Radio On and Off Turn P clockwise to turn the radio on and counterclockwise to turn the radio off. [. . . ] Press ] or [ until Y displays to turn noise filtering on, or until ­ displays to turn noise filtering off. Press Alerts 25 \ to confirm your selection. To transmit to a radio that has QT noise filtering turned on: 1. Select the same channel and Interference Eliminator Code as the other radio. This allows your voice to pass through the QT noise filter on the receiving radio. [. . . ]