User manual MOTOROLA T805

[. . . ] 6 2 ­ CONTACT INFORMATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 3 ­ SAFETY AND GENERAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 APPROVED ACCESSORIES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 ELECTROMAGNETIC INTERFERENCE/COMPATIBILITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The suction cup can then be pressed into the suction cup base and the lever flipped. Attach the UPH to the other end of the gooseneck by sliding it over the hooks on the end of the gooseneck. UPH Suction Cup Base Release Tab 2. Remove the green backing and press the UPH to the desired spot on the dash. 15 3. Remove the protective backing from one side of the patch and press the patch to the bottom of the UPH. Remove the remaining protective backing and press the UPH to the desired spot. To insert a phone into the UPH: Push the side release button to expand the side grippers to their maximum reach. Insert your phone, and gently squeeze the side grippers until the soft rubber edges grip the phone. Check all of the grippers to see if they are interfering with any phone buttons. The bottom grippers are movable to fit around any phone feature that gets in the way. If needed, the bottom grippers can be removed and re-inserted on the top, and the whole UPH flipped upside down. Check again for button interference and choose the direction that fits best. A steady blue light indicates that your phone has successfully connected to your GPS receiver, and once the GPS light is steady orange you will be ready to travel. Note: 10 seconds after successful Bluetooth and GPS connection, all status lights will turn off. To view them again, momentarily press the power button to turn them on. 19 8 ­ Installation and Start Up Before you can use MOTONAV, you must install the program on your Smartphone. This section provides step-by-step instructions on how to set up and use your MOTONAV personal navigation system. Charge the Battery on the GPS Receiver Before starting, charge the batteries completely in both the GPS receiver and your phone. See section 7 ­ GPS Receiver Operating Basics. Installing MOTONAV from the Storage Card You can easily install MOTONAV from the storage card included in your MOTONAV package by following the steps provided below: 1. With your phone on, insert the SD card into the SD slot on your Smartphone. Note: You may need to turn the device on and off, depending on the device type. When prompted to choose an installation location, select Device and press Install. A message should appear saying, "MOTONAV. CAB was successfully installed on your device. " Press Done. Note: If you are using a Motorola Q, and you don't see the MOTONAV shortcut, press Start > Settings > Home screen > Home screen Layout, and select Windows Default. Start MOTONAV by selecting the home screen shortcut or press Start > MOTONAV. [. . . ] Many of the MOTONAV navigation features are disabled when the Demo is running. Opens an information box, providing version and copyright information. Update the MOTONAV software via GPRS or ActiveSync. Tutorial Start Demo About Shortcuts MOTONAV Online Check for Updates Checking for Updates With the update feature, you can update the MOTONAV software "over the air" or, more precisely, without being connected to a computer. Only the software program is updated, not the map data or other program resources such as voice prompts. [. . . ]