User manual MOULINEX LM 3001 FACICLIC & LM 3001,MV

[. . . ] € Never place your fingers or any other object in the blender when the appliance is running. € Do not use the bowls as containers for freezing, cooking or sterilisation. € Place the blender on a flat, stable, heat-resistant, clean and dry worktop. € Do not remove the lid (c4) before the blades have stopped completely. [. . . ] SAFETY LOCKING The appliance can run only when the jug (C) or accessories (D or E) are correctly positioned and locked on the motor unit (A). USING FOR THE FIRST TIME • Before using your appliance for the first time, clean all the accessories (C, D, E, F) in warm soapy water, except for the motor unit (A). CAUTION: The blades are extremely sharp; handle them with caution when using or cleaning the appliance. € Make sure all the packaging has been removed before operating the appliance. € Important note: Turn the speed selector (B) to “0” before placing the blender jug or accessories on the motor unit. € The appliance starts only if the jug or accessory is correctly positioned and locked on its body. USING YOUR APPLIANCE • Moisten the gasket (c2) and position it correctly on the blade unit (c1): the 3 folds of the gasket must be visible once it is in place. If it is positioned in the other direction, you will not be able to lock the blade unit on the jug. Lock it by rotating the blade unit through a quarter turn in the anticlockwise direction. € Introduce the ingredients into the assembled jug without exceeding 14 the maximum level indicated: * 1. 3 - position 1) • Then rotate the blender jug (C) through a quarter turn until the green lock (closed) appears. The jug or accessory is not correctly positioned or locked on the motor unit. Check that the jug or accessories are correctly positioned and locked onto the motor unit as shown in the figure in the manual. The product is not placed on a Place the product on a flat flat, stable, heat-resistant surface. The blender jug gasket (c2) is not positioned correctly or is missing. The gasket on the blade unit (d2) or (e2) is not positioned correctly or is missing. Reposition the gasket on the blade unit (d2) or (e2) and lock it correctly onto the bowl (F). Add liquid Reposition the gasket, the 3 folds should be visible as shown in Fig. Impossible to lock the blade unit with the gasket (c1+c2) on the jug (c3). You can customise your blender and obtain the following accessories from your usual dealer or from an approved service centre: Herb chopper accessory (D), Spice grinder accessory (E), or an additional blender jug (C). 17 RECYCLING • Disposal of the appliance and its packaging materials. The packaging is comprised exclusively of materials that present no danger for the environment and which may therefore be disposed of in accordance with the recycling measures in force in your area. [. . . ] For disposing of the device itself, please contact the appropriate service of your local authority. € End of life electrical and electronic products: Your appliance is expected to last for many years. However, when the time comes to replace it, do not throw it into the bin, but take it to the recycling centre in your town (or to a waste reception centre where applicable). Your appliance contains valuable materials which can be recovered or recycled. [. . . ]