User manual NAVMAN DEPTH 2100

[. . . ] DEPTH 2100 Installation and Operation Manual English . . . . . . . . . . . . . c o m NAVMAN FCC Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a normal installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] If either key is held depressed for more than one second the reading will increase or decrease rapidly. The offset can be programmed in 0. 1 unit steps from -9. 9 to 9. 9 feet (or equivalent). When programmed for a negative offset, `-' will be indicated on the left hand side of the display. To display depth below the keel enter the vertical distance between the bottom of the keel and the depth transducer as a negative value. To display depth below surface enter the vertical distance from the waterline to the depth transducer as a positive number (no negative sign). NAVMAN DEPTH 2100 Installation and Operation Manual 3. After 2 seconds the display will show the Transducer Setting value eg 0. 0. To exit this mode, press and hold both simultaneously. tdr Units of Measure To select the displayed unit 1. Apply power while holding down . V OFF Hold down during power up 5 2. Use and to change the value. 8Ft 888 8FA Feet Metres Fathoms and 4. Alternatively, if no keys are pressed for a period of 5 seconds normal depth display will resume. ON ^ V OFF Press simultaneously The display will now indicate the current water depth in the selected display unit. 3 Dual Station Operation Multiple Depth 2100 instruments can be installed on a single vessel. These instruments can be connected together and configured to operate in a dual station configuration. One instrument is designated as a master and all other instruments, connected to it, are configured as slaves. The master device is connected to the depth transducer and determines the water depth. This information is then displayed on all slave devices connected to it. The slave devices can be configured to operate as fully functional NMEA repeaters where they display water depth, as displayed on the master device, and share common alarm settings and keel offset values. In this mode the common alarm settings can be changed or activated/deactivated from either the master or slave devices. Alternatively, the slaves can be configured to operate as independent slaves. In this mode the slaves display the water depth received from the master, but have independent alarm settings and keel offset values. Note: The instrument designated as the master device is the only instrument connected to the depth transducer. Use Master/Slave Selection To select the master/slave mode of operation: 1. Apply power while holding down . V OFF Hold down during power up 2. The display will first indicate the current display unit: 8Ft Example 4 Maintenance Your depth sounder is designed for years of trouble free operation assuming proper installation and care are provided. [. . . ] Ph: +46 304 360 60 e-mail: info@plastimo. se Website: www. plastimo. se Spain PLASTIMO ESPAÑA, S. A. Avenida Narcís Monturiol, 17 08339 VILASSAR DE DALT, (Barcelona). Ph: +34 93 750 75 04 e-mail: plastimo@plastimo. es Website: www. plastimo. es Portugal PLASTIMO PORTUGAL Avenida de India N°40 1300-299 Lisbon Ph: +351 21 362 04 57 e-mail: plastimo@siroco-nautica. pt Other countries in Europe PLASTIMO INTERNATIONAL 15, rue Ingénieur Verrière BP435 56325 Lorient Cedex, France. Ph: +33 2 97 87 36 59 e-mail: plastimo. international@plastimo. fr Website: www. plastimo. com REST OF WORLD / MANUFACTURERS Navman NZ Limited 13-17 Kawana St. [. . . ]