User manual NAVMAN ICN600 SMART ST2005

[. . . ] Connect the iCN to your PC Use the mains power adaptor (supplied) to plug the iCN into a power socket. Turn the iCN on by holding down the button for 1 second, this screen should be displayed on the iCN. This is a twostep process first download the application, then you must register the installation to activate the software (this requires an Internet connection). Note: the Product Key can be found on the back of the smartMAPTM CD sleeve ­ this is required every time you install and register the smartMAPTM software. [. . . ] Click and hold the mouse button down over the map area you require, and drag it across to one of the righthand windows. Alternatively, you can click on the required map area and it will be displayed in the bottom lefthand screen. The maps available on the supplied CD-ROMs are dependent on the country of purchase. Remove the USB cable The iCN must be un-plugged from the USB cable, in order to complete the installation process. Once the installation is complete, click on "Activate Software" to register your installation on-line. The iCN can be mounted in three different ways: By suction straight onto the windshield By suction or an adhesive disc onto the dash; By directly screwing onto the dash (iCN 630 only). For detailed information on using options 2 and 3, refer to the User Manual, Installing the iCN into your Vehicle. Follow the safety guidelines to ensure that the iCN does not obstruct the view of the driver, or interfere with the operation of any airbags and safety devices in the vehicle. Choose a position on the windshield where the iCN will be clearly visible by the driver without obstructing the view of the road. Hold the suction cup firmly against the windshield and press the lever down until it snaps close. Slip the locking nut loosely over the ball foot, with the flat side facing upwards. No GPS fix, the satellite icon is red and the strength indicators are not displayed. Setting a destination There are three main ways that you can program your destination: Use "SHORTCUTS" that you have previously programmed for destinations used on a regular basis. Set a new "DESTINATION" by entering an address, intersection, Point of Interest, favourite or recently travelled location. refer to the User Manual for information on programming Shortcuts and Favourites. Directly from the map You may find it easier to program your destination directly from the map. The iCN will allow you to scroll around a map and pick a point on the map. Press OK to display grid-lines you are now in the manual Map Browser screen. Use the button to position the intersection of the grid-lines over the destination that you require. Now that you have programmed your destination, its now time to use the iCN 630 on your drive. Viewing your route There are four different ways that you can view instructions along your way. Map browser This view is always oriented to the North, and shows your current position and surrounding street names. [. . . ] Map browser This view is always oriented to the North, and shows your current position and surrounding street names. If you have already programmed a route, the route and all turns are highlighted. Navigation map Similar to the Map Browser view, except that the map is always oriented to the direction in which your vehicle is travelling. Next instruction This view clearly shows the information that you need for the next turn the direction of the turn and the distance to the turn. [. . . ]