User manual NAVMAN MDT850

[. . . ] After a few seconds, the display changes to the received message screen. 3. 0 MDT KEYS Page Up Status Bar Message List Screen Function Keys: Up, Down, Left, Right Page Down Selection Keys Status Bar Backspace Key ENTER Key Backlight Key 2 M D T- 8 5 0 || USER MANUAL Key(s) `Page Up' and `Page Down' `Selection Keys' `Right' and `Left' Function `Up' and `Down' Function `Enter' Used to Scroll through message list Select a highlighted message from the list displayed on screen Go back and forth between messages. Select the digit of a message that needs editing Scroll through list of messages four at a time. Edit value of a message that needs editing Select highlighted message on screen. [. . . ] From the message page, select the previously received message you need using the `Selection' keys 2. Press the `Selection' key that matches the reply 4 M D T- 8 5 0 || USER MANUAL you want 4. You will hear a 2-tone alert when the message is received by the OnlineAVL application 5. The menu will then return to the message page 5. 4 TO SEND AN OUTBOUND MESSAGE This is sending a message to the OnlineAVL application that is not associated with receiving an inbound message on the MDT850 terminal. From the message page, press `ENTER' once without selecting any received message 2. Press the `Page Up' and `Page Down' keys to display the reply options 3. You will hear a 2-tone alert when the message is received by the OnlineAVL application 5. The menu will then return to the message page with your abbreviated reply message in the top right corner 5. 5 TO EDIT A MESSAGE This is only for preset reply messages with numbered areas. Use the `Right' and `Left Function keys to select the digits that need editing 3. Press the `Selection' key matching the edited message to send it 5. You will hear a 2-tone alert when the message is received by the OnlineAVL application 6. The menu will then return to the message page 5 NAVMAN Note: to change a blank space to a number, use the `Up' key. To change a number to a blank space, use the `Down' key after 0. 6. 0 DRIVER ID If the Driver ID (Driver Identification) functionality has been enabled for you MDT by an OnlineAVL user, then a driver is required to enter a Driver PIN to confirm their Driver ID (determined by an OnlineAVL user). The Driver PIN (Personal Identification Number) must be entered within a certain time frame (determined by an OnlineAVL user, eg 40 seconds) after which the MDT will beep until a correct Driver PIN has been entered. The Driver ID Logon screen will appear on the MDT 1012 seconds after the ignition is turned on 2. Use the `Up' and `Down' Function key to change this digit to the first digit of your Driver PIN 3. [. . . ] If you have not being assigned a Driver PIN and the MDT is beeping, contact your office immediately. 6. 4 IF THE VEHICLE IS OUT OF COVERAGE If the vehicle is out of coverage when you are inserting the Driver PIN, the Halo Qube / Dome tracking device will store the information and will send it when it is back in coverage. If you have not logged on while in an out of coverage area, the MDT will not beep until it is back in coverage. 8 CONTACTS Australia Support: +61 2 9879 9000 supportwdgaus@navman. com. au New Zealand Support: 0800 GPS FLEET (0800 477 353) wirelessnzsupport@navman. com United Kingdom Support: 0845 4561660 support@navmanwireless. co. uk Website: www. navman. com © 2005 Brunswick New Technologies Asia Pte Limited. [. . . ]