User manual NAVMAN SMARTCRAFT GATEWAYS

[. . . ] SmartCraft Gateways For single and dual engine applications Installation and Operation Manual www. navman. com NAVMAN ! CAUTION IMPORTANT SAFETY INFORMATION This is the safety alert symbol. It is used to alert you to potential personal injury hazards, Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury CAUTION indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. CAUTION used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage. ! Please WARNING read carefully before installation and use. DANGER ! [. . . ] To further customise the three gauge displays, change Speed range, Speed type and Pitot type (see section 4-7). Press 3 Repeat steps 1 and 2 to change more data items, then press to return to the main display. 20 NAVMAN SmartCraft Gateways Installation and Operation Manual 4-3 Troll control Troll control allows adjustment of the engine's idle speed from the Navman instrument. Troll control automatically controls the engine idle speed to maintain a set engine RPM or boat speed. To use troll control, set Troll window to On idle or Always and set Troll mode to Speed or RPM (see section 4-7). To prohibit troll control, set Troll window to Never (see section 4-7). Engaging troll control 1 Set the throttle(s) to idle and the engine(s) in gear. From a main display, press to display the Troll control window (see right). Notes: 1 The Troll range of engine idle RPM adjustment available for both RPM and speed mode depends on engine type. In speed troll control, the boat might not reach the desired speed if the maximum RPM available for troll control is too low or if conditions are bad. Troll can not engage unless engine throttle(s) are in idle, and engine(s) are in gear. To use speed troll control, the Navman instrument must have a Navman paddlewheel speed sensor connected. 2 3 Changing RPM or speed while troll control engaged 1 2 3 From a main display, press the troll window. to display or to change the desired RPM or Press boat speed (see notes 1 and 2). Press 2 Disengaging troll control Either move the throttle from idle, or: 1 From a main display, press or the troll window. to display to select Off 3 4 5 2 to leave troll control 4-4 Trim indicator When the optional engine trim is adjusted, a trim popup window can show the new trim angle. To see this window or not, set Trim popup to On or Off (see section 4-7: Trim). The window will automatically disappear after two seconds, or else press to close the window. Before use, calibrate trim (see section 4-7: Trim). NAVMAN SmartCraft Gateways Installation and Operation Manual 21 4-5 Engine fault alarms There are many SmartCraft engine fault alarms. These alarms operate just like the other alarms in the Navman instrument; when the alarm sounds, to mute the alarm: press Low reserve oil. A Navman instrument's low battery alarm measures the voltage at the instrument; the above two alarms measure the voltage at the engine. Engine communication lost: The Navman instrument can not receive engine data from the SmartCraft gateway. For more information about the alarm, display the list of active alarms or the alarm history (see section 4-6). Notes: 1 2 For help when an SmartCraft alarm occurs, contact your Mercury dealer. A list of active faults and a fault history can be displayed (see section 4-6). 3 4-6 Engine fault lists There are two lists of SmartCraft engine faults: When the faults list is displayed Press list. or to page up and down the 4-6-1 Engine faults list To display a list of active engine fault alarms: press , select SmartCraft, then select Engine faults. To display more information about a particular fault: i ii Press Press or to select the fault. [. . . ] Ph: +56 2 698 0055 Fax +56 2 698 3765 e-mail: mmontecinos@equimar. cl Mera Vennik Colon 1148, Talcahuano, 4262798, Chile. Ph: +56 41 541 752 Fax +56 41 543 489 e-mail: meravennik@entel. chile. net www. navman. com Taiwan Seafirst International Corporation No. Ph: +886 7 831 2688 Fax: +886 7 831 5001 e-mail: seafirst@seed. net. tw web: www. seafirst. com. tw Thailand PING Electric Co. , Ltd. 2/80 Sreesutus Road, Russada Muang Phuket 83000 Thailand Tel: +66 (76) 224847 Fax: +66 (76) 252144 pingelectric@yahoo. com Vietnam HaiDang Co. [. . . ]